Loading ...
Loading ...
Loading ...
•Tum the unit upside down on a flat
surface. Straighten out chain, then lay
iton a flat surface.
Adjusting
Screw
Bar Nuts
• Remove bar mountingnuts, bar
clamp plata, and old chain.
• Turnthe adjustingscrew counter-
dookwisa to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the unit.
REPLACEMENT SAW CHAIN
• See "Customer Serviceable Parts'. A
chain must comply with the kickback
performance requirements of ANSI
B175.1 when tested with this saw.
• Hold chain with cutters facing as
shown.
Tipof Chain
Bar Saw
\
CUBERS MUSTFACEIN
DIRECTIONOF ROTATiON
• Slide the chain between the housing
and the sprocket. Place chain around
the sprocket and fit the drive links into
the guide bar groove and then around
guide bar nose.
Sprocket
• Hold the guide bar against the saw
frame and install thebar clamp plate.
Be sure the tab on the bar clamp
plate is toward the rear of bar.
,.,..=_ AdjustingPin Slot -.
laD
Plate _ II
, Secure the guide bar and bar clamp
plate with the bar nuts; tighten finger
tight only..
CAUTION: If saw chain is installed
backwards, the saw will vibrate exces-
sively and will not cut wood.
CHAIN ADJUSTMENT
See "Check Chain Tension" in
Maintenance section.
CUSTOMER SERVICEABLE PARTS
WARNING: Use of any other acces-
sory or attachment might present a risk
of iniury to the operator.
REPLACEMENT PART PART NO.
Hex Nuts
Oil Cap
Guide Plate
Safety Lock Button
Bar AdjustingScrew
Bar AdjustingPin
Spacer
Spacer Screw
File(5/32"d'_)TwinPak
Rle Guide (Re Holder)
Depth Gauge Tool
Xtra GUARD ®Chain -16"
Lo-lrucke Guide Bar - 16"
Bar & Chain Lubricant-1 qt
Bar & Chain I.ubricant-1 gal
5300153O3
_82
530029285
53OO25873
,5,3O015514
53O023492
530015832
530015835
7136524
7136565
7136557
713629
I 7136366
:7136556
7136554
Rig
14
Loading ...
Loading ...
Loading ...