Loading ...
Loading ...
Loading ...
37
Fig. 37-1 - Wire diagram
A
B
D
24" model shown
(connections may vary)
Power supply
box
Wire harness
extension
Left interior
oven light
Main burner
Igniters
Backburner
Igniter
Igniter
module
Igniter
switch
Light
switch
CONTROL PANEL REMOVAL
1. Turn the control knobs to the OFF position and turn off the gas supply
to the grill.
2. Turn off the light switch and disconnect the unit from the power source.
3. Pull the control knobs from their stems and set them aside.
4. Slowly lift away the lighted bezels to clear the valve stems, and carefully
disconnect the wires found on the back of the bezels (use your fingernail).
See Fig. 37-1.
5. Using a Phillips screwdriver, unscrew the control panel fastener screws (located
on the sides of the control panel). Retain the screws for later re-installation.
6. Carefully open the control panel by lifting and pulling the control panel from the frame.
Important: When opening, take caution to not damage any wiring. The drip tray can be opened slightly to support the
control panel.
To completely remove the control panel:
1. Follow steps 1-5 above.
2. Disconnect the main wire harness connections (A), the left light connection (B), the right light connection (C),
and the igniter wires (D). It is recommended to temporarily label the wires for reference when reconnecting.
See Fig. 37-1. When disconnecting, be sure to pull from the connectors, and not the wires.
Note: Secure any disconnected wires (coming from the inside of the grill) to prevent them from falling into the unit.
3. Carefully remove the control panel.
Note: Whenever reconnecting any wires, apply a small amount of dielectric grease to the male connector, then make
the connection. This will ensure conductivity and prevent moisture from affecting the contact.
Important: During reinstallation; prior to opening the gas shut-off valve, be sure the control knob(s) are in the OFF position.
Fig. 37-1
Remove
bezel
Carefully
disconnect
Lighted bezels
(disconnected)
C
Right interior
oven light
Converter
harness
AC/DC
converter
Ground wire
connection
CONTROL PANEL REMOVALSERVICING AND CLEANING (Cont.)
Loading ...
Loading ...
Loading ...