Loading ...
Loading ...
Loading ...
21
CONNECT THE GAS SUPPLY (cont.)
1. Route the attached flex connector with regulator
(located underneath the grill) to the gas-supply
stub. (An adapter is required if the gas-supply stub
is other than
1
/
2
" in diameter.)
2. Turn OFF the gas supply at the source. Then
connect the regulator to the gas-supply stub. Use
pipe joint compound that is resistant to all gasses
on the male pipe fitting and tighten securely. DO
NOT use pipe joint compound to connect flare
fittings.
Note: The regulator may need to be disconnected
from the flex connector to make the proper
connections. Reconnect the flex to the
regulator if removed.
3. Turn all burner control knobs to the OFF position.
Turn the gas supply on. Then carefully check all gas
connections for leaks with a brush and half-soap/
half-water solution before lighting. Never use a
match or open flame to test for leaks.
4. Close the shut-off valve, then slide the grill into place.
Do not to pinch, kink, or damage the gas connector
line.
INSTALL THE VAPORIZER PANELS
Place the vaporizer panels directly onto the studs on the
burners. See Fig. 21-2. The panels allow heat from the
burners to be evenly distributed throughout the cooking
area. The panels are stainless steel and will heat and cool
quickly, making your grill very responsive to the changes
you specify in grill temperature. They are rust resistant
and may be cleaned with standard oven cleaners. Some
discoloring will be seen with use. This is normal for
stainless steel and does not affect the function.
Flex connector
Adapter
Regulator
6" Grill clearance
Gas
supply
INSTALLATION (Cont.)
Fig. 21-1 Household propane & natural gas diagram
Shut-off valve
(required, not included,
must be installed within 6
feet of the unit)
Fig. 21-2 Install vaporizer panels
Place onto studs
Loading ...
Loading ...
Loading ...