Loading ...
Loading ...
Loading ...
2 MbN: “Sensitivity level” a MSELECTN
3 M
bN: Select the desired setting. a MSAVEN
a MOFFN
Answering the baby monitor
Handset / Base unit
n When monitoring with a unit:
Handset: Press M
N to answer a call.
Base unit: Press M
N to answer a call.
If you want to respond from the monitoring unit,
press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom feature
is set to “On” (page 31).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
MOFFN, then press M
N.
– To answer the call with the base unit, press
M
N 3 times.
*1
*1 If MMUTEN is pressed, press M
ZN 2 times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature by
pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
The default handset name is “Handset 1” to
“Handset 6”. You can customize the name of
each handset (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 55).
Handset
1 MMENUN#104
2 Enter the desired name (10 characters max.).
a MSAVEN a MOFFN
Displaying the handset name
You can select whether or not the handset name
is displayed in standby mode. The default setting
is “Off”.
Handset
1 MMENUN#105
2 M
bN: Select the desired setting. a MSAVEN
a MOFFN
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
R See page 4 for information on the available
model.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1 Handset:
MMENUN#130
2 Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing, press
MLOCATORN again to stop, then repeat this
step.
3 Handset:
Press MOKN, then wait until a long beep
sounds.
For assistance, please visit http://shop.panasonic.com/support
55
Programming
TGF88x(en)_1104_ver033.pdf 55 2019/11/05 13:22:55
Loading ...
Loading ...
Loading ...