Loading ...
Loading ...
Loading ...
6
MILK COOLERS FORCED AIR & COLD WALL
OPERATIONS MANUAL
DOOR LATCH AND LID LOCK
To open your milk cooler, unlock the lid by turning the key so
the cam disengages from the keeper (see Figure 4). Lift the lid
and slowly rotate it back, so it rests against the bumpers. Locate
the door latch on the interior side wall. Lift up on the front of
the latch and rotate it back, to disengage it from the keeper.
The door will now freely rotate down. Lower it gently so it rests
against the front bumpers. To close, lift the door back into place
and rotate the latch to engage the keeper. Close the lid by rotat-
ing forward and lower it into place, so the clips engage into the
accepters at each end of the door.
NOTE: The lid clips and accepters secure the door, so
it cannot be opened until after the lid is unlocked and
opened. Always close the door before closing the lid.
LATCH ADJUSTMENT AND LOCK REPLACEMENT
If the lid or door does not close properly, check alignment of
the clips on underside of the lid and the accepters inside the
door (see Figure 4). To adjust, loosen the screws, move clip or
acceptor to position desired and retighten the screws. Use the
same method to adjust the latch keeper if needed. To remove
the lid lock, start on the inside. Use a large philips screwdriver
to turn the lock screw counter-clockwise to loosen it. Remove
the screw and cam. Use a large wrench to turn the nut counter-
clockwise and remove it. From outside the lid, pull the tumbler
out of the hole. To replace the lock, reverse the above steps.
CLIP
ACCEPTER
KEY
LOCK
LOCK KEEPER
DOOR
LATCH KEEPER
TUMBLER
SCREW
CAM
NUT
DOOR LATCH
LID
LID
CLIP
FIGURE 4: Door Latch and Lid Lock
RIGHT SIDE
OF CABINET
FIGURE 5: Forced Air Top Removal
(Dual Access Model Shown)
SILICONE
SEALANT
TOP ASSEMBLY
FRONT
BACK LID
LID
(SHOWN
OPEN)
HINGE
FRONT DOOR
BACK
DOOR
(REMOVED)
RECEPTACLE
ELECTRICAL
CONDENSER
FRONT GRILL
DRAIN CONNECTION
[COLD-WALL MODELS
W/MECHANICAL CONTROL]
COMPRESSOR
TEMP. CONTROL
LID
FRONT DOOR
(OPENED)
MILK COOLER COMPONENTS
[COLD-WALL MODEL SHOWN]
ELECTRONIC
CONTROL
FIGURE 3: Milk Cooler Components (Cold-Wall Models)
Loading ...
Loading ...
Loading ...