Loading ...
Loading ...
Loading ...
12
WOOD STOVE QUICK START GUIDE
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 877-447-4768 8:30 a.m. – 4:30 pm CST, Monday – Friday.
or email us at [email protected]
10
Slide Bafe Rod shown
in “CLOSED” postition.
ITEMS NEEDED FOR FIRST FIRE:
• 6 Pieces of Seasoned Split Wood 15-17 in. Long
Once fire is fully burning, fully close and
latch stove door.
9
LATCH STOVE DOOR
CLOSED
8
REDUCE AIR CONTROL
Position Damper Slide to Fully
Open Setting for 7 Minutes, then
set to Desired Setting. Leave Door
open approximately 12 inches for
approximately 4 Minutes.
OPENCLOSED
OPEN
CL
OSED
PULL
PUSH
Engagement
Pin
SlideB
af
fl
e
RodH an
dle
Always OPEN the Slide Baffle before opening the door to refuel the stove! This will prevent:
• Spillage of smoke, flame and carbon monoxide
• Spillage of sparks, coals and logs
• Over-firing
Insure the slide baffle is in the CLOSED position after the Door is closed to activate the
Efficiency and Fuel Saving design of this stove.
DO NOT leave the stove unattended with the door open.
Starting a fire may not require an open door to draft. The air control should supply adequate
draft.
Pull Rod Handle out to rotate between
“CLOSED” and “OPEN” position.
“PUSH” Rod Handle in to lock in
position. Congratulations! Your wood
stove is ready for operation.
This wood heater has a manufacturer-set minimum low burn rate
that must not be altered. It is against federal regulations to alter
this setting or otherwise operate this wood heater in a manner
inconsistent with operating instructions in this manual.
Note: The BTU ratings mentioned above are based on the EPA test protocol under specific test conditions. Our advertised BTU’s are
based on the first hour of operation at high burn rate burning dry cordwood.
Efficiency, Heat Output, and Particulate Emissions:
The Weighted Average HHV Efficiency = 75.3
The Sum of Weighted Particulate Emission = 1.48 grams/hour
Heat Output Range = 16,394 - 70,045 BTU/hour
WARNING! Risk of Fire
7
FUEL LOADING
CONFIGURATION
Configure the Fuel as Follows;
1. Position 3 Large Logs Front-to-Back on Top
of the Ember Bed.
2. Position 3 Large Logs Side-to-Side on Top of
the First Layer
Si
de
-to-
S
Fr
ont-to-Bac
k
Large
Logs
15"-17" Lon
g
Embe
rs
Loading ...
Loading ...
Loading ...