Loading ...
Loading ...
Loading ...
4. Open the drain valve fully to
permit air to escape and prevent
air pressure build up in the air tank
during the break-in period.
5. Move the Auto/Off lever to "Auto"
position. The compressor will
start.
6. Run the compressor for 20
minutes. Make sure the drain
valve and all air lines are open so
there is only a minimal air pressure
build-up in tank.
7. Check all air line fittings and con-
nections/piping for air leaks by
applying a soap solution. Correct
if necessary. NOTE: Minor leaks
can cause the air compressor to
overwork, resulting in premature
breakdown or inadequate perfor-
mance.
8. Check for excessive vibration.
Readjust or shim air compressor
feet, if necessary.
9. After 20 minutes, close the drain
valve. The air receiver will fill to
"cut-out" pressure and the motor
will stop.
The compressor is now ready for use.
Before Each Start=Up:
1. Place Auto/Off lever to "Off".
2. Close the globe valve/air
discharge valve.
3. Visually inspect air lines and
fittings for leaks.
4. Check safety valve. See To
Check Safety Valve under
Maintenance.
_Risk of unsafe
-- operation. Firmly
grasp air hose in hand when
installing or disconnecting to
prevent hose whip.
Risk of unsafe
operation. Do not
use damaged or worn accessories.
NOTE: A regulator MUST be installed
when using accessories rated at less
than 175 psi.
NOTE: The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick con-
nect socket.
Risk of Bursting.
Too much air
pressure causes a hazardous
risk of bursting. Check the
manufacturer's maximum pressure
rating for air tools and accessories.
The regulator outlet pressure must
never exceed the maximum pressure
rating.
Risk of unsafe
operation.
Compressed air from the unit may
contain water condensation and
oil mist. Do not spray unfiltered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the instructions for the air
tools and accessories.
How to Start:
1. Turn the Auto/Off lever to "Auto"
and allow tank pressure to build.
Motor will stop when tank pres-
sure reaches "cut-out" pressure.
2. When the tank pressure reaches
"cut-out" pressure open the globe
valve.
IMPORTANT: When using regula-
tor and other accessories refer to the
manufacturers instructions.
_lf any unusual
__ noise or vibration
is noticed, stop the compressor
immediately and have it checked by
a trained service technician.
The compressor is ready for use.
15-ENG
Loading ...
Loading ...
Loading ...