Loading ...
Loading ...
Loading ...
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - Electric drill
Unpacking
1. Remove all packaging.
lt may be necessary
to brace or support
one side of the outfit when removing
the pallet because the air compressor
will have a tendency to tip.
2. Remove and discard the screws
and washers holding the com-
pressor to the pallet.
3. With the help of another person
carefully remove air compressor
from pallet and place on a level
surface.
_Risk of property dam-
age. This compres-
sor was shipped with oil in the pump
crankcase. Check oil before operating
air compressor, see Check Oil under
Maintenance.
HOW TO SET UP YOUR UNiT The air compressor MUST be bolted
Location of the Air Compressor
• Locate the air compressor in a
clean, dry, and well ventilated
area.
Located the air compressor at
least 12" (30.5 cm) away from
the wall or other obstructions
that will interfere with the flow
of air.
Locate the air compressor as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electri-
cal wiring could cause power
loss to the motor.
The air filter must be kept clear
of obstructions which could
reduce air flow to the air com-
pressor.
Anchoring of the Air Compressor
_Risk of Bursting.
__ Excessive
Vibration can weaken the air tank
and cause an explosion. The
compressor must be properly
mounted.
to a level, solid concrete surface. Use
3/8" lag screws, washers and concrete
anchors. If help is needed anchoring
the air compressor consult a licensed
contractor.
1. Place the air compressor on a
level, solid concrete surface.
Make sure the concrete is in
good condition with no cracks or
damage.
2. Mark the surface using the holes
in the air compressor feet as a
template.
3. Drill holes in the surface for the
concrete anchors. Install concrete
anchors.
4. Line-up holes in surface with holes
in air compressor feet.
5. Place the washers (supplied)
between the floor and air
compressor feet, see figure. If
needed use shims to level the unit.
...........l 3/8" Lag
..... i Screw .
Washer ! _ (not supplied)
(supplied) i....[_ ...................J
sh_Surface Line
Washer (not Concrete Anchor
supplied) (not supplied)
10-ENG
Loading ...
Loading ...
Loading ...