Loading ...
Loading ...
Loading ...
15 INCH TRUE
ICE
TM
MACHINE INSTALL GUIDE
TEC_TM_073 REV. B
04/15/2020 Page 45 of 54
WATER FILTER REPLACEMENT
The built-in water filter is designed to filter
sediment, remove unpleasant taste and odor and
inhibit scale. The filter is shipped inside the ice
machine and must be installed prior to running the
ice machine. Install the filter by inserting it into the
opening on the front of the machine and twisting it
clockwise to lock it in place.
NOTE: PRIOR TO INSTALLATION OF THE FILTER,
LUBRICATE THE O-RINGS OF THE FILTER.
THE ICE MACHINE WILL NOT MAKE ICE IF THE
WATER FILTER IS NOT INSTALLED.
The life expectancy of the filter is twelve months for
low-scale water and six months if the water has a
high level of scale. The ice machine monitors how
long the filter has been in operation and will display
“FLT” when the filter needs to be replaced.
Replacement water filters are available through your
True dealer.
CAUTION: DO NOT ALLOW THE ICE MACHINE TO
BE EXPOSED TO TEMPERATURES BELOW 32˚F
(0˚C) AS THIS WILL CAUSE ANY WATER IN THE
MACHINE OR IN THE WATER FILTER TO FREEZE.
FAILURES CAUSED BY EXPOSURE TO FREEZING
TEMPERATURES ARE NOT COVERED BY THE
WARRANTY.
REPLACEMENT PARTS
True maintains a record of the serial number
for your unit. If at any time during the life of
your unit, a part is needed, you may obtain
that part by furnishing the model number and
serial number to the company from whom you
purchased your machine.
For replacement parts contact your True dealer
or call True parts department at 844-849-6179.
Inquiries can be sent to:
info@true-residential.com
(636) 240-2400 • toll free (888) 616-8783
CONDENSER CLEANING
INSTRUCTIONS
• Keeping the condenser coil clean will minimize
required service and lower electrical cost.
• The condenser coil should be cleaned by
removing dust and other build-up from the
tube assembly with vacuum or a clean rag.
1. Remove kickplate.
2. Vacuum or use clean rag to remove dust
build-up from coil.
3. Re-install kickplate.
KICKPLATE
Loading ...
Loading ...
Loading ...