Loading ...
Loading ...
Loading ...
15 INCH TRUE
ICE
TM
MACHINE INSTALL GUIDE
TEC_TM_073 REV. B
04/15/2020 Page 15 of 54
ELECTRICAL SPECIFICATIONS
WARNING: THIS APPLIANCE MUST BE PROPERLY
GROUNDED. DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND) PRONG
FROM THE POWER CORD. FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE PROPERLY GROUNDED.
The electrical outlet must be within three feet of
the center of the back wall of the ice maker’s final
location. Outlet must be flush with wall and comply
with local electrical codes.
Before your new unit is connected to a power supply,
check the incoming voltage with a volt meter. If
anything less than 100% of the rated voltage for
operation is noted, correct immediately.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with
a standard three-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard from
this appliance. A 115V AC, 60 Hz, 15 amp circuit
breaker and electrical supply are required.
Each unit requires a dedicated circuit. Have the wall
outlet and circuit checked by a qualified electrician to
make sure the outlet is properly grounded.
If the outlet is a standard
two-prong outlet, it is your personal
responsibility and obligation to have
it replaced with the properly
grounded three-prong wall outlet.
Do not use an extension cord or
two-prong adaptor. Electrical ground
is required on this appliance.
The unit should always be plugged into its own
individual electrical circuit which has a voltage rating
that matches the rating plate. This provides the best
performance and also prevents overloading house
wiring circuits which could cause a fire hazard from
overheated wires. Never unplug your ice machine by
pulling on the power cord. Always grip plug firmly and
pull straight out from the outlet.
Repair or replace immediately all power cords that
have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage
along its length or at either end. When moving the ice
machine away from the wall, be careful not to roll over
or damage the power cord.
The unit is approved by UL for outdoor installation.
OUTDOOR USE
All True undercounter ice machines are UL-rated for
outdoor use.
When installing outdoors, keep in mind that certain
regions may experience colder ambient temperatures
than others. When this decrease in temperature
occurs, the unit may stop producing ice before it is
full and begin showing FUL on the display. This is
caused because the internal thermostat has reached
the cut off temperature. Furthermore, these stainless
steel cabinets are very heavily insulated and will retain
the cold temperature for long periods of time.
The location of the unit will also play a factor in the
false full reading. If the unit is built into a kitchenette
area, within stone, brick, or wood etc., this will
further delay the reaction time. Basically, even if your
temperatures increase during the day, your cabinet
may be holding the colder temperature from the
evening before.
If your unit is showing a false full reading, rub your
hand on the inside ice level bar.
Once it senses the warm temperature it will start ice
production again. It is recommended during colder
periods to increase the ice level using the adjustment
screw. It is located behind the louver grill on the front
of the cabinet. The level can be increased by turning
the screw clockwise.
Loading ...
Loading ...
Loading ...