Loading ...
After removing the drawer identify which type of regulator is installed on the range by comparing to
the photos below. Follow the appropriate conversion instructions found on the following pages.
Hex Shaped Cap
Aluminum Top I
Fig. 3 Aluminum Regulator i
Plastic Dust Protector I
I Fig. 4 Steel Top Regulator I
iNSTRUCTiONS FOR CONVERTING ALUMINUM REGULATOR:
If the regulator has an aluminum top as pictured in Fig. 3 convert the regulator in the following manner:
A. Remove the regulator access cover if equipped. Do not remove the Pressure Regulator or allow it to turn.
B. Unscrew the hex shaped cap and turn it over to access the conversion plug inside the cap. (Fig A)
Do not remove the spring from the regulator.
C. Rotate the plug 90 degrees in either direction to align the tabs on the plug with the notches in the cap. (Fig. B)
Lift the plug out of the cap.
D. Turn the plug over so that the
nib on then end of the cap faces
out and re insert into the cap.
Rotate the plug 90 degrees in
either direction to lock it into the
cap (Fig C)
E. Reinstall the cap and plug
securely onto the regulator.
F. Attach the LP conversion label
as illustrated on page 8 then
complete the remaining steps in
the instructions provided with
the LP kit.
i CONVERSION PLUG [ TO UNLOCK J
REINSTALL PLUG
WITH NIB POINTING UP
INSTRUCTIONS FOR CONVERTING STEEL TOP REGULATOR: If the regulator has a steel top as pictured in Fig. 4 above
convert the regulator in the following manner:
A. Remove the regulator access cover if equipped. Do not remove the Pressure Regulator or allow it to turn.
B. Remove the plastic dust protector from the cap (Fig 5). Using a 5/8" wrench, unscrew the cap from the pressure regulator (Fig 6).
Do not remove the spring from the regulator.
C. Turn the cap over so the hollow end faces outward. Place the solid end of the cap into the loop end of the dust protector
(See Fig. 7).
D. Replace the cap on the regulator with the hollow end facing out (Fig 8). Do not over tighten the cap. Snap the dust protector over
the regulator cap.
E. Attach the LP conversion label as illustrated on page 8 then complete the remaining steps in the instructions provided with the LP
kit.
NOTE: The pressure regulator cap
may be made d brass or aluminum
depending on the age of the
product. The conversion process is
the same for both types of caps.
Loading ...
Loading ...
Loading ...