Loading ...
Loading ...
Loading ...
STEP3.Attacha3/4-inch,U.L.-listed,
strainrelieftotheholebelowterminal
blockopening.Strainreliefshouldhave
atightfitwithdryercabinetandbeina
horizontalposition.Putthepowersupply
cordthroughthestrainrelief.
STEP4.Loosenorremoveterminalblock
screws.Connecttheneutralwire(white
orcenter)ofpowersupplycordunder
thecenterscrewoftheterminalblock.
STEP5.Connecttheothertwowires
toouterterminalblockscrews.Tighten
allterminalblockscrewsfirmly.
Externalground
connector
Neutral_
Center silver-colored
terminal block screw
_ White
-- _.'-) neutral
wire
3/4",&L-listed,
strainrelief
3-Wire Connection with
Frame-Grounding Conductor
STEP 6. Tighten the strain relief screws.
STEP 7. Insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down screw.
if local codes do not permit the
connection of a frame-grounding
conductor to the neutral wire, see
the instructions on page 15.
Otherwise, proceed with Exhaust
installation. See "CONNECT
EXHAUST" on page 19.
II. THREE-WIRE ELECTRICAL
CONNECTION (DIRECT WIRE)
Prepare cable as directed:
Electrical Shock Hazard
Turn power supply off before
connecting wires.
Use 10 gauge solid copper wire.
Electrically ground dryer.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
The dryer can be connected directly
to fused disconnect or circuit breaker
box with three-wire, flexible armored
or non-metallic sheathed copper cable
(with grounding wire). All current-carrying
wires must be insulated.
A conduit connector must be installed at
junction box. Allow four feet of slack in the
line so dryer can be moved if servicing
is ever necessary.
GROUNDING INSTRUCTIONS
This appliance must be connected to
a grounded metal, permanent wiring
system; or an equipment-grounding
conductor must be run with the circuit
conductors and connected to the
equipment-grounding terminal or
lead on the appliance.
STEP 1. Turn power supply off.
STEP la. Strip 31/2 inches of outer
covering from end of cable. If using
3-wire cable with grounding wire, cut
the bare wire even with outer covering.
_31/2" I
I3
Loading ...
Loading ...
Loading ...