Loading ...
Loading ...
Loading ...
4 Configuration D-Link Smart Managed Switch User Manual
20
Note:
For the PoE Port Settings table, if the
classification was shown as “Legacy PD”, it will be
classified to non-AF PD or Legacy PD.
Note: This switch conforms to IEEE 802.3af and 802.3at standards. The IEEE
PoE standard requires a switch to shut off power to a port if the power draw is
less than 10mA within a 400ms time interval. To support some non-standard
devices that may take longer, you may enable this feature to extend the time
interval to 500ms. If the PD is still not powering on, please contact the vendor
of your device for support.
Management > Password Access Control
The Password Access Control page allows the user to configure the access password of the Switch.
Figure 4.19 – Management > Password Access Control
The fields that can be configured for Password Access Control are described below:
Item Description
Old Password
Enter the old password of the Switch.
New Password
Enter the new password of the Switch.
Confirm Password
Enter the new password of the Switch again.
Table 4.6
Click Apply to make the configurations take effect.
Management > SNMP > SNMP Global Settings
Simple Network Management Protocol (SNMP) is an OSI Layer 7 (Application Layer) protocol designed
specifically for managing and monitoring network devices. SNMP enables network management stations to
read and modify the settings of gateways, routers, switches, and other networks. Use SNMP to configure
system features for proper operation, monitor performance and detect potential problems in the Switch or
LAN.
This panel allows the user to configure the SNMP settings, used for managing and monitor devices on the
network.
Figure 4.20 – Management > SNMP > SNMP Global Settings
The fields that can be configured are described below:
Item Description
Loading ...
Loading ...
Loading ...