Loading ...
Loading ...
Loading ...
4 Configuration D-Link Smart Managed Switch User Manual
1
1
9
9
0 Default 15.4W
1 Optional 4.0W
2 Optional 7.0W
3 Optional 15.4W
4 Optional 30W
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. You can select From Port / To Port to control the PoE functions of
a port. The DGS-1100-05PD/08P will auto disable the ports if port current is over 375mA in 802.3af mode or
625mA in pre-802.3at mode.
Note: Maximum time(interval) that Ping can
respond, when wire-rate and PoE-compatible two
ports are used at the same time
Figure 4.18 – System > PoE > PoE Configuration
The fields that can be configured for PoE Configuration are described below:
Item Description
From Port / To Port
Specifies the PoE function of a port or ports.
State
Select enable or disable
to configure PoE function for
designated port(s). Default is Enabled.
Priority
Configure the power supply priori
ty as “Low”, “Normal”, or
“High” on designated port(s). Default is Normal.
Legacy Support
Specify to enable or disable detecting legacy PDs signal
Power Limit
This function allows you to manually set the port power current
limitation to be given to the PD. To protect the DGS-1100-
05PD/08P and connected devices, the power limit function will
disable the PoE function of the port when the power is
overloaded. Select from "Class 1", "Class 2", "Class 3",
“Class 4” and "Auto" for the power limit. "Auto" will negotiate
and follow the classification from the PD power current based
on the 802.3at standard.
Max. Wattage
Check the box and input the power budget (from 1000 to 8000
milliwatts for DGS-1100-05PD and 1000 to 30000 milliwatts for
DGS-1100-08P) to manuall
y assign an upper limit of port
power budget on designated port(s).
Table 4.5
Click Apply to make the configurations take effect.
Click Refresh button to update the port PoE status information.
Loading ...
Loading ...
Loading ...