Loading ...
Loading ...
Loading ...
page 4
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
pin
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball off
of the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack from
the upper end of the downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip previously removed. Tighten yoke set screws
and nuts securely. [Refer to diagram 2.]
Slide yoke cover, canopy ring and canopy over
downrod. [Refer to diagram 3.] (Note: Canopy ring must
be turned with the smooth, rounded edge toward the
motor housing.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop pin
into top of downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the hanging ball.
Tighten set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming loose
and possibly falling.
["Fan Assembly" continued on next page.]
5. Fan Assembly (with downrod).
set screw
hanging ball
stop pin
diagram 2
diagram 1
downrod
electrical wiring
safety cable
yoke set
screw
and nut
clip
diagram 3
diagram 4
set screw hole
hanging
ball
stop pin
canopy
yoke cover
canopy ring
downrod
motor
housing
Loading ...
Loading ...
Loading ...