Loading ...
Loading ...
Loading ...
RUSH™ MH10 Beam FX User Manual 19
DMX channel mode
You can control the fixture in two modes:
Basic (24 channel mode) controls all 24 cells of the LED ring together, so they
will be all the same color in RGB mode (though FX animations for the ring are
provided).
Extended (93 channel mode) allows you to control the 24 cells of the LED ring
separately using 24 groups of RGB control.
See “DMX protocol” on page 32 for a table showing the function of each DMX
channel.
To adjust the setting:
1. Select CHANNEL MODE and press ENTER. The currently set option will
blink in the display.
2. Use the DOWN and UP buttons to select Basic 24ch (default) or Extended
93ch.
3. Press ENTER to save your selection.
Behavior without DMX (DMX State)
The DMX STATE setting determines how the fixture behaves when it is not
receiving a DMX signal. You can set the fixture to enter Show Mode, black out,
or hold the effect it was displaying when the DMX signal stopped. The fixture is
set to HOLD by default.
To adjust the setting:
1. Select DMX STATE and press ENTER. The currently set option will blink in
the display.
2. Use the DOWN and UP buttons to select SHOW MODE (fixture enters
Show Mode), BLACKOUT (fixture blacks out) or HOLD (fixture shows the
last effect it was displaying before the DMX signal stopped).
3. Press ENTER to save your selection.
Stand-alone settings
The fixture will operate in stand-alone mode if it is not receiving a DMX signal
and the DMX STATE menu option is set to SHOW MODE (see above), or if
you enter the SHOW MODE menu in the control panel.
Stand-alone show selection (Show Mode)
Four pre-programmed stand-alone shows are available. To set the show that
the fixture will run in Show Mode:
Loading ...
Loading ...
Loading ...