Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 1-800-887-6326
Monday – Friday 9:00 a.m. – 5:00 p.m. CST
SKU Number: 346-7201
18″ ADD ON UNDER CABINET LIGHT
Model Number: U2104
HARDWARE CONTENTS Note: Hardware not shown actual size.
PACKAGE CONTENTS
Drywall Screw
X2
AA
CC
BB
Mounting Clip
X2
Link Cord
X1
211109
A
Works With SKU# 346-7200
As Child Light Only
Page 2 of 4
SAFETY INFORMATION
TION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
● LED electronics can be damaged by electro static discharge (ESD) shock. Before installation, discharge yourself
by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Phillips Screwdriver, Safety Glasses, Ladder.
ASSEMBLY INSTRUCTIONS
1. ● Identify and mark the desired location for the LED
fixture, then place the mounting clips (AA) in the
desired location and mark the intended positions
of the holes with a pencil.
● The distance between two mounting clips (AA)
should be less than the length of the light, but
more than half the length of the light.
Installation Steps
Important to know
1. The fixture is dimmable, but it must be work with
SKU# 346-7200 to achieve this funtion.
2. Do not use in wet locations, use indoors only.
3. Non-replaceable LEDs.
4. Caution: LEDs emit bright light. Avoid looking directly into the
light source for prolonged periods to avoid eye damage.
5. Specifications: Refer to the right chart.
6. Work with SKU# 346-7200 as child light.
NO.
1
18
2.5
Dimension(inch)
Item #.
346-7201
A
B
C
0.38
Watts
12
211109
1
AA
AA
BB
Drywall
2
A
C
B
2. For mounting to drywall:
Drill holes at the two locations. Position the mounting
clips (AA) on the locations on the drywall, then secure
them with drywall screws (BB).
Page 3 of 4
ASSEMBLY INSTRUCTIONS (continued)
Spare Parts List:
Assembly Kit
6423MM (1 SET)
The following parts are available for re-order if damaged or missing. Call our toll free at 1-800-887-6326
4. Attach the light fixture (A) to the mounting clips (AA) by
sliding one side of the fixture into the mounting clips (AA)
first, then press and push the other side of the fixture into
the mounting clips (AA).
211109
AA
BB
Wood
3
5
CC
DD
IR Sensor Switch
4
AA
A
Drywall Screw
X2
AA BB
Mounting Clip
X2
CC
Link Cord
X1
3. For mounting to wood:
Drill holes at the two locations. Position the
mounting clips (AA) on the locations on the
wood, then secure them with drywall
screws (BB).
5. Linking multiple fixtures:
The fixture can be connected together in a series using the
link cord (CC) included with this product. Must work with
SKU# 346-7200 as child light. The fixture can be linkable
up to a set of SKU# 346-7200 maximum.
1. This fixture can be connected by inserting the link
cord (CC) into the connecting hole at the end of the fixtures.
When using the link cord (CC), the maximum distance
between two light fixtures is 18" and the connector of the
link cord ("TOP" mark) must be consistent with the
light-emitting surface.
2. Provide power to the fixtures only after all linking connections
have been made.
SKU# 346-7200 (Sold Separately)
SKU# 346-7201
Page 4 of 4
211109
Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 1-800-887-6326
Monday – Friday 9:00 a.m. – 5:00 p.m. CST
TROUBLESHOOTING
CARE AND MAINTENANCE
Caution: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or
removing the fuse from the fuse box.
This LED light fixture is made from quality materials that will last many years with minimum care. You may want to
periodically clean the fixture with a soft cloth. To maintain the best appearance of the fixture, do not use cleaners with
chemicals, solvents or harsh abrasives. Do not use liquid cleaner on the LEDs, LED drive, or wiring inside the light
fixture.
POSSIBLE CAUSE CORRECTIVE ACTION
It will not light up when separated use.
Must be work with 346-7200.
Check to ensure the circuit
breaker is in the on position.
Check to ensure proper wire
connections are made. Contact a
qualified electrician.
The circuit breaker is off.
There is a bad connection.
PROBLEM
If unable to fix any of the above issues, please consult a certified electrician.
The fixture doesn't light up.
FIVE-YEAR LIMITED WARRANTY: If, during normal use, this PATRIOT LIGHTING lighting fixture breaks or fails
due to a defect in material workmanship within five (5) years from the date of original purchase, simply bring this
lighting fixture with the original sales receipt back to your nearest MENARDS retail store. At its discretion, PATRIOT
LIGHTING agrees to have the product or any defective part(s) repaired or replaced with the same or similar PATRIOT
LIGHTING product or part free of charge, within the stated warranty period, when returned by the original purchaser
with original sales receipt. This warranty; (1) excludes expendable parts including but not limited to light bulbs; (2) does
not cover damage that has resulted from abuse or misuse; and (3) does not cover any losses, labor, injuries to
persons/property or costs. This warranty does give you specific legal rights and you may have other rights, which vary
from state to state.
R
R
R
R
Too many fixtures connected. Linkable up to three fixtures at most. The light flashes.
The wires are crossed or the power
wire is grounding out.
Check to ensure proper wire
connections are made. Contact a
qualified electrician.
The fuse blows or circuit
breaker trips when the light
is turned on.
