Xenon Puck Light Installation Instructions
Installation instructions for Models 346-8010, 346-8011, 346-6705,
346-6712, 346-6713, 346-6714, 346-6719, 346-6720 and 346-6721
WARNING:
These products may represent a possible shock or fire hazard if improperly installed or attached in any way.
Products should be installed in accordance with these instructions, current electrical codes and/or the current
National Electric Code (NEC). Disconnect power to the unit prior to installation.
NOTE: Puck light kits are not extendable. The maximum number of pucks that can be powered from one power
cord or hardwire junction box (Patriot Lighting part number 346-6472, sold separately) is limited by the fact that one
puck in each kit will have a lead wire only (no tail wire). A single puck kit contains a puck light with only a lead wire
and therefore it cannot be used to extend other kits (to create a series of pucks powered by one power cord).
Please see illustrations below as examples for 3-pack and 5-pack combinations to create longer runs, however,
note that when combining more than two packs, do not exceed ten puck lights in a single run.
©2011 Distributed by Menard, Inc
Eau Clarie, WI 54703 Made in China
A centrally located hardwire junction box (Patriot Lighting part number 346-6472, sold separately)
used in conjunction with two 5-pack puck light sets will allow ten puck lights to be powered by a single
power source. Note: In this example, two power cords (one included with each kit) are not used.
Also, 12” extensions (included with each kit) are required between pucks but are not shown.
Two 5-pack puck light sets can be recombined to create one series of
nine puck lights and a separate single puck light set. Note: 12” extensions
(included with each kit) are required between pucks but are not shown.
A 3-pack and a 5-pack can be recombined to create one series of
seven puck lights and a separate single puck light set. Note: 12” extensions
(included with each kit) are required between pucks but are not shown.
IMPORTANT SAFETY INSTRUCTIONS: PLEASE SAVE!
This fixture has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk of
electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless
the plug can be fully inserted. Do not alter the plug.
CONTINED ON NEXT PAGE
Loading ...
Loading ...
