Loading ...
Loading ...
Loading ...
SECTION 3- OPERATING INSTRUCTIONS
3.3 STARTING ENGINE -
(Continued from previous page)
5. Move Engine Speed Control fully up to CHOKE
position. See Figure 3.13.
NOTE: Engine will not start unless transmission is in
NEUTRAL position and Blade Clutch Switch is in OFF
position.
WARNING ILI
DO NOT leave machine with engine running. Stop I
engine. Stop blades. Lock traction levers. Remove I
key. DO NOT park machine on slopes. I
3.4 MACHINE MOVEMENT
3.4.1. FORWARD MOTION.
1. With both traction levers locked, depress
Operator's Presence Control (OPC) against handle.
See Figure 3.16.
.
FIGURE 3.13
Turn Key Switch to RUN position. See Figure
3.14.
FIGURE 3.14
7. Pull Recoil Starter Handle and Engine should start.
See Figure 3.15. (NOTE: Several pulls may be
necessary to start engine.)
IMPORTANT: DO NOT jerk the engine recoil starter
handle or allow it to snap back.
.
FIGURE 3.16
(Right hand shown;
left hand identical)
Move Transmission Shift Lever in No. 1 position
(first gear). See Figure 3.17.
.
FIGURE 3.15
After engine starts, move Engine Speed Control
back to FAST (rabbit) position.
12
FIGURE 3.17
.
Squeeze both Traction Levers firmly against handle
grips. Traction Locks are spring-loaded and will
snap back to the "Unlocked" position. Using
caution, slowly and simultaneously release
pressure on both Traction Levers. The machine
will begin to move forward.
(Continued on next page)
Loading ...
Loading ...
Loading ...