Loading ...
Loading ...
Loading ...
Installingthedryer.
Read these instructions completely and carefully.
GasConnectionforGasDryers
[-_ Rentove the shipping cap from gas pipe at tile
rear of tile dtTer.
NOTE:DONOTconnect tile dryer m LP gas setx_ce
without converting tile gas valve. An LP conversion
kit (Pub. No. 14-A038) MUSTbe installed bya
qualified gas technician.
[] Connect a 1/2" (1.27 cm) I.D. semi-rigid
or approved pipe from gas supply line to
the 3/8" (0.96 cm) pipe located on the back
of the dryer. Use a 1/2" to 3/8" (1.27 cmm
0.96 cm) reducer for a connection. Apply an
approved thread sealer that is resistant m the
CO1TOSiveaction of liquefied gases on all pipe
connections.
I-j] Open the shutoffvalve in the gas supply line.
[-_ Test all connections by brushing on a soapy water
solution.
CAUTION:NEVERTESTFORGASLEAKSWITH
AN OPENFLAME.
NOTE:On gas dryers, before the burner will light,
it is necessary fbr the gas line to be bled of air. If
the burner does not light within 45 seconds the first
time the dryer is turned on, the safety switch will
shut the burner off. If this happens, mm the timer
m OFFandwait 5 minutes before making another
attempt m light.
BeforeOperatingtheDryer
Connect the exhaust duct to outside exhaust
system. Use duct tape to seal all joints.
[2-_With the dryer in its final position, adjust one or
more of the legs until tim dryer is resting solidly
on all fbur legs. Place a level on top of the dryer.
THEDRYERMUSTBELEVELANDRESTING
SOLIDLYONALLFOURLEGS.Turn tile lock nuts
on each of the fbur legs up toward tile base of the
dryer and snug with a 1/2" open-end _u'ench.
I-j] Plug the power cord into a grounded oudet.
NOTE:Cl{eck to ensure the })ower is offat circuit
breaker/fuse box befbre plugging the power
cord into tile outlet.
[_ Turn on the at the circuit breaker/
power
fuse box.
CAUTION:Before operating tim dryer, make
sure the dryer area is clear and flee front
combustible materials, gasoline, and other
flmmnable vapors. Also see that nothing
(such as boxes, clothing, etc.) obstructs the
flow of combustion and ventilation air.
_-]Run the dryer through a cycle check for proper
operation.
[-6-]If your dryer does not operate, please review the
TroubleshootingTips section in this manual befbre
calling fbr set-dce.
_-] Place these instructions in a location near the
dryer for future reference.
18
Loading ...
Loading ...
Loading ...