Loading ...
Loading ...
Loading ...
" iii i i iii • i IIIHI I I
TROUBLE SHOOTING POINTS
iiiiii = i iii i1= i = HUH
TROUBLE SHOOTING CHART
i
i ii =
SYMPTOM
Engine will notstart or
willrun only for a few
seconds after starting,
CAUSE
,,,,,,, ,,,,,,,,,,, L
1. Fuel tank empty.
2. Engine flooded,
3. Spark plug notfiring.
4. Fuel not reaching carburetor.
5. Carburetor requires adjustment,
6. Air filter dirty.
7. Fuel filter dirty.
8. None of the above.
Engine willnot idle
properly. 2.
3.
i, , ,
Engine willnot
accelerate, lacks
power,or dies
under a load.
Engine smokes
excessively.
1. Idle speed set too fast ortoo stow.
Carburetor requires adjustment,
None of the above.
1. Air filter dirty.
2. Spark plugfouled.
3. Carburetor requiresadjustment.
4. Muffleroutletsplugged.
5. None ofthe above.
,,,,,,,,,,,,,,,,,,,,,i,,
1. Air filter dirty.
2. Fuel incorrect.
3. Carburetor requires adjustment.
...........,,,,i,,,i ,, ii
Engine runs hot. 1.
2.
3.
4.
iJ-,
Cutting attachment
moves at idle speed,
Fuel incorrect.
Carburetor settoo low (lean).
Spark plugincorrect.
None of theabove.
, ,,,,,,,,,,,,,,,,,,: ,, i
1, Carburetor requiresadjustment.
2, Throttlecable binding.
3. Clutchrequires repair,
,,,,, ,, ,
Cutting blade stops 1. Forcing blade into material being cut,
under a load or does 2. Blade clogged withdebris,
not turn when the 3. None of the above.
engine is accelerated,
CORRECTION
, L •
1. Filltank with correct fuel mixture.
2. See "Starting Instructions:
3. Installnew plug!checkignitionswitch.
4. Replace fuelfilter;, inspectfuel line.
5. See "Carburetor Adjustments;
6. Clean or replaceair filter.
!7. Contact your SEARS Service Center/Dept.
8. Contact your SEARS Service Center/Dept.
J
1, See "CarburetorAdjustments."
2. See "Carburetor Adjustments."
3. Contact your SEARS Service Center/Dept.
1. Clean or replace air filter.
2. Claan and re-gap or replacespark plug.
3, See "Carburetor Adjustments;
4. Contact your SEARS Service Center/Dept,
5. Contact your SEARS Service Center/Dept,
,,,,, =
1, Clean or replace air filter.
2. Refuel with correct fuel mixture,
3, See =Carburetor Adjustments:
1. See "Fueling Your Unit."
2. See "Carburetor Adjustments."
3. Replace withcorrectplug.
4, Contact your SEARS Service Center/Dept.
1. See "Carburetor Adjustments."
2. Contact your SEARS Service Center/Dept,
3. Contact your SEARS Service Center/Dept.
, ,,,,,
1. Cut at a slower pace.
!2. Clean debris from blade.
3. Contact your SEARS Service Center/Dept.
ff situationsoccur which are notcovered in this manual usecare and good judgemenL
ff you need assistance, contact your SEARS Service Center/Department or the
CUSTOMER ASSISTANCE HOTLINE at 1-800-235-5878.
-18-
Loading ...
Loading ...
Loading ...