Loading ...
Loading ...
Loading ...
i ,,,, ,,,,i,u,iiiiii m. ,,,,,i,,,,, i ilUl u i,iiiii i
OPERATION
=11 ,,,,,= i = , ,=,= i
STOPPING "fOUR ENGINE
• Move the ONIOFF switchtothe OFF position.
• If engine does not stop, movethechoke levertothefull
choke position.
THROTTLE TRIGGER (Fig. 3)
The throttle trigger controlsthe enginespeed.
NOTE: The blade should stop when the throttle trigger is
released and the engine returns to idlespeed.
THROTrLE TRIGGER
Figure 3
OPERATIN G/USE TIPS (Fig. 4)
w...,.o
ALWAYS CUT AT MAXIMUM SPEED. DO
NOT CROWD THE BLADE INTO THE CUT
WHICH CAN DAMAGE THE BLADE,
BECOME ENTANGLED, OR BE THROWN
CAUSING A SERIOUS HAZARD.
ALWAYS WORK GOING AWAYFROM PEO-
PLE AND SOLID OBJECTS SUCH AS
WALLS, LARGE STONES, TREES, AUTO-
MOBILES, ETC.
ALWAYS WEAR EYE PROTECTION.NEVER
LEAN OVER THE BLADE. ROCKS OR
DEBRIS CAN RICOCHET OR BE THROWN
INTO EYES AND FACEAND CAUSE BLIND-
NESS OR OTHER SERIOUS INJURY.
• Allow the cutting blades to reach full speed before
entering the material to be cut.
• Always work going away from people and solid objects
such as walls, large stones, trees, automobiles,etc.
• If blade stalls, immediately stop the engine. Make sure
the ON/OFF switch is off, the spark plug is disconnect-
ed, and the blade has stopped moving before clearing
ioammeddebris from the cutting blade.Inspect the blade
r damage and have _trepaired or replaced as needed.
° To stop the engine, move the ON/OFF switch to the
OFF position.
o Always keep the air vents clean. Stop the unit, make
sure the cutting blade has completely stopped moving,
and disconnect the spark plug before cleaning.
AIR VENTS
TRIMMING METHODS (Fig.5_ & 6)
NOTE: Do nottryto cut stems larger than 3/8" thick.
TOP cu'n'ING
• For new or young growth: When trimming new or
younggrowth,use a wide, sweeping motion. Figure 5A.
A slight,downwardtiltof the cuttingblades in the direc-
tion ofmotion gives the best cuttingresults.
• For older, thicker growth: Trim older, thicker growth
byusinga sawingmotion. Figure5!3.
• For precise, level cuts: If a precisely level cut is
desired, stretch a piece of string across the length of
the hedge. Guide the cutting blades slowly across the
top ofthe string.Figure 6.
SIDE cu'n'ING
• When tdmming the sides of the hedge, begin at the
bottom and cut upward, tapering the hedge inward at
the top., Figure 6' (inset). Cutting in this method will
leave the body of the hedge narrower at the top.This
shape willexpose more ofthe hedge, resulting in more
uniform growth.
A B
Figure 5
Figure 6
Figure 4
-10-
Loading ...
Loading ...
Loading ...