Loading ...
Loading ...
Loading ...
STEP3: (SEEFIGURE3)
• Attachtheframebracebetweenthefrontmount
platesusingtwo1/2"x1-1/4"hexbolts,1/2"x 1-1/2"
washersand1/2"nylocknuts.
FIGURE 3
STEP 5: (SEE FIGURE 5)
= Remove the thread forming bolt from the hole in the
footrest bracket on the left side of the tractor frame.
= Attach the L.H. hanger bracket to the empty hole
using a 5/16" x 1" hex bolt, a 5/16" lock washer, and
a 5/16" fiat washer. Place the fiat washer between the
hanger bracket and the footrest bracket.
= Repeat on the right side of the tractor frame using the
the R.H. hanger bracket.
5116" FLAT
WASHER
FOOTREST
BRACKET
L.H. HANGER
BRACKET
5/16"LOCK
WASHER
5116" x 1"
HEX BOLT
STEP 4: (SEE FIGURE 4)
Measure from the center of the three holes indicated
in figure 4 to select the hole that is approximately 10"
above the ground in both front mount plates.
Install a shoulder bolt and 3/8" nylock nut in the
selected hole in each front mount plate.
/
SHOULDER BOLT /
318"NYLOCK NUT
Use hole that measures
10" above ground
FIGURE 4
FIGURE 5
STEP 6: (SEE FIGURE 6)
Turn the clutch idler assembly upside down.
Attach the spring from the parts bag to the bottom of
the upper idler arm. Hook the spring onto the bolt that
extends through the nut on the bottom of the upper
idler arm and then install a 3/8" hex lock nut onto the
bolt. Leave enough space for the spring to pivot.
3_"HEX
LOCK NUT
©
ATTACH
SPRING
HERE
FIGURE 6
4
Loading ...
Loading ...
Loading ...