Loading ...
Loading ...
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
(2) 3/4" Wrenches
(1) Knife
ADDITIONAL ITEMS REQUIRED
General Purpose Grease
Remove all loose parts, parts bags and hardware
bags from the snow thrower and this kit. Lay out and
identify parts and hardware using the illustrations.
IMPORTANT: Not all items supplied with the
snowthrower and this kit will be needed for your particular
tractor. Unneeded items may be discarded after you have
completed assembly and checked operation of unit. DO
NOT DISCARD the two spare shear bolts and 5/16"
nylock nuts supplied with the Snow Thrower.
CAUTION: Before starting to assemble the
snow thrower, remove the spark plug wire(s),
set the parking brake and remove the key
from the tractor ignition.
IFYOU HAVE A 247..28884 OR 247.28885
TRACTOR, GO TO ASSEMBLY
INSTRUCTIONS ON PAGE 8.
STEP 1: (SEE FIGURE 1)
Assemble a shoulder bolt and a 3/8" nylock nut to the
holes shown on each side of the tractor frame.
SHOULDER
BOLT
FIGURE 1
\
3/8" NYLOCK NUT
TRACTOR PREPARATION
Before performing these instructions, refer to the Service
and Adjustments section of your tractor owner's manual
for specific safety instructions.
Allow engine, muffler and exhaust deflector to cool
before beginning.
Remove any front or rear attachment which is
mounted to your tractor.
Remove the mower deck. Refer to your tractor owner's
manual for removal instructions. Mark all loose parts
and save for reassembly.
Remove the tractor hood. Refer to your tractor owner's
manual for removal instructions.
IMPORTANT: Right hand (R.H.) and left hand (L.H.) side
of the tractor are determined from the operators position
while seated on the tractor.
STEP 2: (SEE FIGURE 2)
Place a front mount plate onto each shoulder bolt and
install two quick release pins as shown.
QUICK RELEASE PIN
\
FRONT MOUNT PLATE
SHOULDER
BOLT
FIGURE 2
Loading ...
Loading ...
Loading ...