Loading ...
Loading ...
Loading ...
ATTACHING SNOW THROWER TO TRACTOR
STEP 1:
o
o
(SEE FIGURE 22)
Place the snow thrower on a fiat, level surface.
Extend the auger belt out behind the snow thrower,
leaving the belt assembled to the snow thrower pulleys.
Roll the tractor up behind the snow thrower, centering
it between the snow thrower's mounting plates.
Raise the rear of the snow thrower by lifting up on
the lift handle until the notches inthe mounting plates
align with the shoulder bolts in the tractor's side
plates. Guide the bolts intothe notches.
Delay installingthe clevis pins until you have
assembled the belt as instructed in steps 23 and 24.
1/8" HAiRPiN
COTTER
/
SHOULDER
BOLT
MOUNTING
PLATE
FIGURE 38 RIGHT SiDE ViEW
STEP 2: (SEE FIGURE 23)
The auger belt comes pre-assembled to the pulleys on
the snow thrower housing. Make sure the belt passes
over the top of the auger pulley and then twists 1/4
turn to pass underneath each side idler pulley. The
"V" side of the belt must mate with the grooves of the
pulleys.
TWIST
1/4 TURN
iDLER
PULLEY
AUGER PULLEY
TWIST
1/4TURN
PULLEY
FIGURE 39
14
iNSTALLiNG THE AUGER BELT
STEP 1: (SEE FIGURE 24)
Push the lift handle down to increase slack inthe belt
(attachment pin must first be removed).
Swing the idler arm over to the side.
Place the auger belt around the rear pulley and
between the two idler arm pulleys. The "V" side of the
belt must be seated in the grooves of the V-pulleys.
install the two 1/2" x 7/8" clevis pins and 1/8" hairpin
cotters.
LEFT SiDE
OF TRACTOR
\
REAR
PULLEY
iDLER ARM
FLAT PULLEY
iDLER ARM _PULLEY
AUGER
BELT
FIGURE 40 VIEWED FROM UNDERNEATH
BELT ROUTING DIAGRAM
_ ENGINE PULLEY
Loading ...
Loading ...