Loading ...
Loading ...
Loading ...
19
EN
www.napoleongrills.com
N415-0543 DEC 12.18
Geng Started
1. Remove all cart panels, hardware, and grill head from the carton. Raise lid and remove any
components packed inside. Use the parts list to ensure all necessary parts are included.
2.
3. Assemble the grill where it is to be used, lay down cardboard or a towel to protect parts from being
lost or damaged while assembling.
4. Most stainless steel parts are supplied with a protective plastic coating that must be removed
prior to using the grill. The protective coating has been removed from some of the parts
during the manufacturing process and may have left behind a residue that can be perceived as
scratches or blemishes. To remove the residue, vigorously wipe the stainless steel in the same
direction as the grain.
5.
Two people are required to set the grill head into the enclosure.
If you have any quesons about assembly or grill operaon or if there are damaged or missing parts
please call our Customer Soluons Department at 1-866-820-8686 between 9 AM and 5 PM (Eastern
Standard Time).
CAUTION! During unpacking and assembly we recommended you wear work gloves and
safety glasses for your protecon. Although we make every eort to make the assembly process
as problem free and safe as possible, it is characterisc of fabricated steel parts that the edges and
corners might be sharp and could cause cuts if handled incorrectly.
TOOLS REQUIRED FOR ASSEMBLY (tools not included)
WARNING! Construcon materials and masonry dust may cause surface damage to units and
accessories. The best opon is to install components aer all construcon has been completed and
the jobsite has been thoroughly cleaned. If the components must be installed prior to the construcon
being completed, then exposed surfaces need to be covered to prevent corrosion. All surfaces must be
cleaned when construcon is completed. Do not use muriac acid to clean masonry materials
from any
surfaces. The lime contained in some construcon materials is extremely corrosive. During its curing
period, (1 - 2 months) it is recommended that a stainless steel polish or wax (car wax is acceptable) be
applied to prevent direct contact of the lime materials.
3/8" (10mm)
!
!
N415-0543 DEC 12.18.indd 19 12/13/2018 10:19:20 AM
Loading ...
Loading ...
Loading ...