Loading ...
Loading ...
Loading ...
A: Usage Situations where Appliance Power Cord wilt
be Disconnected Infrequently_
TEMPORARYMETHOD
(Adapterplugs not _--_,_
permitted in Canada) _-._ -_ l
Ah'gnlarg pge ron s/slots _ ;"}[__'_i)It_ll__-_J'
t _=r-- En_remPrcOpenrg_OUnnd
,jJ before use
An adapter may be used only on a 15-amp circuiL Do not
use an adapter on a 20-amp circuiL Where local codes
permit, a TEMPORARY CONNECTION may be made to
a properly grounded two-prong walt receptacle by the use
of a ULqisted adapter, available at most hardware stores.
The larger slot in the adapter must be aligned with the
larger slot in the walt receptacle to provide proper polarity
in the connection of the power cord.
CA UTIO N: Attaching the adapter ground
terminal to the wall receptacle cover screw does not
ground the appliance unless the cover screw is metal,
and not fnsulated, and the wall receptacle is grounded
through the house wiring, The customer should have
the circuit checked by a qualified electrician to make
sure the receptacle is properly grounded,
When disconnecting the power cord from the adapter,
always hold the adapter with one hand., tf this is not done,
the adapter ground terminal is very likely to break with
repeated use, Should this happen, DO NOT USE the
appliance until a proper ground has again been
established°
B: Usage Sftuatlons where Appliance Power Cord will
Be Disconnected Frequently.
Do not use an adapter plug in these situations because
disconnecting of the power cord places undue strain on
the adapter and leads to eventuat failure of the adapter
ground terminal The customer should have the two-
prong wall receptacle replaced with a three-prong
(grounding) receptacle by a qualified electrician before
using the appliance
The installation of appliances designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or,
when such standard is not applicable, the Standard for
Manufactured Home Installations, latest edition
(Manufactured Home Sites, Communities and Set-Ups),
ANSI A225.1, latest edition, or with local codes. In
Canada, mobile home installation must be in accordance
with the current CAN/CSA Z240/Mtl Mobile Home
Installation Coder
Electric Disconnect
1. Locate disconnect plug on the range back,
2. Pinch sides of connector and pull out of range back.
You will have this disconnect plug:
STEP 4
Seal the Openings
Seal any openings in the wali behind the range and in the
floor under the range when hookups are completed.
(continued next page)
35
Loading ...
Loading ...
Loading ...