Loading ...
Loading ...
Loading ...
12 49-2000664 Rev. 2
CARE AND CLEANING
RANGETOP EXTERIOR
Do not use oven cleaners, abrasive cleansers, strong liquid
cleansers, steel wool, plastic scouring pads, or cleaning
powders on the cooktop surface. Clean with a mild soap
DQGZDWHURUDVROXWLRQRIYLQHJDUDQGZDWHU5LQVH
with clean water and dry with a soft cloth. When cleaning
surfaces, make sure that they are at room temperature and
not in direct sunlight.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up as soon as hot surfaces cool,
Then clean and rinse.
Stainless Steel
Do not use a steel wool pad; it will scratch the surface. To
clean the stainless steel surface, use warm sudsy water or
a stainless steel cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the cleaner instructions
for cleaning the stainless steel surface. Cleaners with
oxalic acid such as Bar Keepers Friend Soft Cleanser™
will remove surface rust, tarnish and small blemishes. Use
only a liquid cleanser free of grit and rub in the direction of
the brush lines with a damp, soft sponge. To inquire about
purchasing cleaning products including stainless steel
appliance cleaner or polish, see the Consumer Support
section for further information.
CONTROL PANEL AND KNOBS
It’s a good idea to wipe the control panel after each use.
Clean with mild soap and water or vinegar and water,
rinse with clean water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control panel
because they will damage the finish.
For easier cleaning, the control knobs may be removed by
pulling them directly outwards once the knobs are in the
OFF position. Do not pull knobs up or down or hang objects
on them. This can damage the gas valve shaft. See the
Surface Burner section for a detailed view of these knobs.
The knobs can be washed by hand with soap and water.
When removing burner knobs, remember their location.
The knobs are not interchangeable, these knobs must be
placed in the same location after cleaning. See the Surface
Burner section for a detailed view of these knobs. To
replace knobs after cleaning, align the bottom of the knob
with the matching clip orientation to the shaft inside the
bezel. Push knob until completed seated.
Use a soft, non abrasive cloth to clean the inside of the
bezel. Do not remove diffuser film. Do not expose to
moisture or it will damage lighting electronics.
%HVXUHHOHFWULFDOSRZHULVRႇDQGDOOVXUIDFHVDUHFRROEHIRUHFOHDQLQJDQ\SDUWRIWKHUDQJH
GriddleFront
Control Panel
Flat Side
Flat
Side
OFF OFF
Burner Knobs
Loading ...
Loading ...
Loading ...