Loading ...
Loading ...
Loading ...
This is not a do-it-yourself project. Failure to have this appliance installed by a licensed and certified electrician and
plumber will void all warranties.
Under no circumstances should you attempt to clean, install, inspect, repair, disassemble or service the Maxwell electric
tankless water heater without first shutting off all power to the unit directly at the circuit breaker box. SERIOUS BODILY
INJURY OR DEATH COUILD OCCUR IF THIS WARNING IS IGNORED.
INSTALLATION OF THIS PRODUCT IS RESTRICTED TO INDOOR LOCATIONS BY QUALIFIED PLUMBING,
HEATING, MECHANICAL, ELECTRICAL CONTRACTORS ONLY, IN ACCORDANCE WITH ALL NATIONAL,
STATE, PROVINCIAL, AND LOCAL ELECTRICAL AND PLUMBING CODES.
By installing this product you acknowledge the terms of manufacturer's warranty and your authorized dealers return
policy. Water heaters that have been installed cannot be returned. If you plan to install your water heater on a second
floor/above ground or in a heated attic space you must follow all code requirements for installation in your area. It is
highly recommended to install a drip pan connected to a safe drain as per code requirements below the water heater
to avoid property damage in case of eventual leaks, and / or install an active water leak detector and shut off valve to
turn off your water supply in the event that a leak is ever detected.
Installation of this product is restricted to indoor locations only.
2. ABOUT YOUR ELECTRIC TANKLESS WATER HEATER
Please read thoroughly and understand this safety and installation manual completely before beginning to enjoy your
new on demand electric Maxwell tankless water heater, as it contains important safety information and installation
instructions.
If you need assistance or have any questions please contact us at: (305) 593-8358
Please keep this manual for future reference and technical information.
1. WARNINGS
3
Rear Cover
Temp. Controller
Heating Chamber
Thermal cut-out
(Manual Reset)
Triac
Temp. Sensor
Water Outlet
Connection
Control Board
Flowmeter
Temp. Sensor
Water Inlet
Connection
MS-C2TMU
Stainless Steel Model
MS-C2T_U
Injected Mold Model
Triac
Stainless Steel
Rear Cover
Thermal cut-out
(Manual Reset)
Temp. Sensor
Water Outlet
Connection
Water Inlet
Connection
Temp. Sensor
Flowmeter
Control Board
Picture 2 Picture 3
Terminal Block
Terminal Block
Loading ...
Loading ...
Loading ...