Loading ...
Loading ...
Loading ...
30
Cooking containers
IMPORTANT: if the pots are not correctly sized, the cooking zones will not turn on
For details of the minimum pot diameter that needs to be used on each zone, see the illustrated part of this manual.
Recommended pan bottom diameters
Important:
to avoid permanent damage to the hob surface, do not use:
- containers with less than perfectly flat bottoms.
- metal containers with enamelled bottoms.
- containers with a rough base, to avoid scratching the hob surface.
- never place hot pots and pans on the surface of the hob's control panel
Use only pots bearing the symbol
Pre-existing containers
Induction cooking uses magnetism to generate heat. Containers must therefore contain iron. Check if the pot material is magnetic
using a magnet. Pots are not suitable if they are not magnetically detectable.
Using the extractor fan
The extraction system can be used in two versions: external extraction and evacuation or as a filter with internal recirculation.
Extraction version
Fig.7
The fumes are evacuated towards the outside through a series of pipes (bought separately) fastened to the supplied connecting
flange.
The diameter of the exhaust pipe must be equivalent to the diameter of the connecting ring:
- for rectangular outlets 222 x 89 mm
- for circular outlets Ø 150 mm (*)
For more information, see the page relative to the extraction version in the illustrated part of this manual. Fig. 7.6.a - 7.6.b
Connect the product to wall-mounted exhaust pipes and holes with a diameter equivalent to the air outlet (connecting flange).
Using wall-mounted exhaust pipes and holes with a smaller diameter may reduce the efficiency of extraction and drastically increase
noise levels.
All responsibility in this regard is therefore denied.
Keep duct as short as possible.
Use ducting with the least possible number of curves (maximum angle: 90°).
Avoid drastic changes in the ducting diameter.
Filtration version
Fig. 8 10
The extracted air will be filtered in special grease filters and odour filters before being sent back into the room.
The product is NOT supplied with the necessary components for installation of the Filtration version. The FILTRATION KIT must be
purchased separately.
There is a set of filters in the kit which capture the odours thanks to the activated carbon, plus the instructions for assembling the kit.
For more information, see the page relative to the filtration version (in the illustrated part of this manual).
Note: for the filtration kit, we always recommend making an opening in the cabinet plinth to facilitate air recirculation.
Loading ...
Loading ...
Loading ...