Loading ...
Loading ...
Loading ...
PROBLEM CAUSE SOLUTION
Saw does not start. 1. Motor cord or wall cord is not 1. PJugin motor cord or wail cord.
plugged in.
2, Circuit fuse is blown.
3, Circuit breaker is tripped.
2. Replace circuit fuse.
3+ Reset circuit breaker.
4, Cord or switch is damaged. 4. Have the cord or switch re-
placed at your nearest Sears
Service Center.
Saw is noisy when running.
1, Motor needs attention.
1. Have the motor checked at
your nearest Sears Service
Center.
Motor is slow or weak.
1, Voltage from source is low.
2, Windings are burned out or
open.
!. Request a voltage check from
the power company.
2. Have the motor checked at
your nearest Sears Service
Center.
Motoroverheats.
3. Start switch is defective.
4. Circuit is overloaded with
appliances, lights, or other
motors,
5. May be wired for 240 volts
instead of 120 volts.
1. Motor is overloaded.
2. Dull blade.
3. Sawdust inside saw is blocking
air flow.
3. Have the switch replaced.
4. Do not use other appliances or
motors on the same circuit
when using the saw.
5. Check wiring of the saw with
info and diagrams in Changing
the motor voltage in the
Assembly Section.
1. Request a voltage check from
the power company.
2. Replace the blade.
3. Clean out the saw base.
Motor stalls, blows fuses, or trips
circuit breakers.
1. Starter switch is defective.
2. Voltage from source is low.
3. Dull blade.
1. Have the switch replaced.
2. Request a voltage check from
the power company.
3. Replace the blade.
4. Fuses or circuit breakers are
wrong size or defective.
4. Replace fuses or circuit
breakers.
5. Feeding workpiece too rapidly. 5+ Feed workpiece into blade
slower.
49 £RRFTSMRN' TABLESAW315.228590
Loading ...
Loading ...
Loading ...