Loading ...
Loading ...
Loading ...
INSTALLING THE FRONT RAIL
See Figures 15, 16, and 17.
• Locate the front rail, the switch assembly, and the
following hardware:
5 square head bolts (5/16-18 x 3/4 in.)
5 flat washers (5/16 in.)
5 hex nuts (5/16-18)
Right and left end caps for front rail
4 screws (#8-32 x 1/2 in.) for end caps
• Set aside the end caps and four screws until the
MDF table extension and switch have been
installed.
• Insert the five square head bolts into the table and
extension, so the bolt heads extend out 1/2 in.
• Loosely attach a flat washer and a hex nut to each
bolt. See Figure 15.
• The back of the rail has two slots, See Figure 16.
Slide the upper slot over the bolts. (Bottom slot is
for switch.)
• Align the rail left to right - Match the 6-7/8 in. mark
on the right scale to the right edge of the saw base
(main table). See Figure 17.
• Snug the rail against table. Finger-tighten each nut
on the table and extension.
SCALE
RAIL SLOT
HEXNUT
FRONTRAIL
Fig. 16
TABLETOPVIEWEDFROMABOVE
SCALE
J
FRONTRAIL
HEIGHT
HANDWHEEL
SQUAREHEAD
BOLT
HEXNUT
FLATWASHER
Fig. 15
Fig. 17
ASSEMBLING MDF TABLE EXTENSION
See Figure 18.
• Locate the MDF table extension and the small
hardware bag with the following:
4 square head bolts (5/16-18 x 3/4 in.)
4 hex nuts (5/16-18)
4 flat washers (5/16 in.)
• Insert the four square head borts intothe holes
located on the front and rear edges of the MDF
table extension. The square boltheads must
extend out.
• Attach a flat washer and a hex nut to each bolt.
Finger-tighten each nut on the MDF table exten-
sion until head of bolt is approximately 1/8 in. from
the frame of MDF table extension. Leave just
enough clearance so that bolts do not rotate and
bind when sliding in rail slots.
• The back of the front rail has two slots. See Figure
16. Slide the bolt heads intothe upper slot of front
rail. (Bottom slot is for switch.)
23 CRRFTSMRWTABLESAW315.228590
Loading ...
Loading ...
Loading ...