Loading ...
Loading ...
Loading ...
Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose
parts, and hardware from the packing materials, check all items with the loose parts list and drawing. If you are
unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until
you have obtained the missing part(s).
INSTALLING HANDWHEELS ON SAW BASE
See Figure 6.
• Each handwheel bag contains a metal handwheel,
a screw (#10-24 x 1/2 in.), and a lock washer (#10).
• Align the handwheels to the shaft ends that extend
from the front and right side of the table saw base.
Match the flat spots on the shaft and inside the
handwheel. Insert a screw and a lock washer in the
handwheel center and tighten with a 4 mm hex
key.
BEVEL
HANDWHEEL
TABLE
HANDWHEEL
SHAFTEND
LOCK
WASHER
SCREW
Fig. 6
Note: Prior to assembly; clean the
protective coating from the
top, sides, and ends of the
table top on your saw. Also
clean protective coating from
the cast iron extension table.
CARRIAGE
BOLT
I
Note: If you mount the saw base on a bench instead
of the legs, go to Table Extensions, page 21.
The bench surface must have an opening for
sawdust to fall through, as large as the opening
in the bottom of the saw base. A height of 36 in.
from the top of the saw table to the floor is
recommended.
ASSEMBLING STEEL LEG STAND
See Figures 7 and 8.
• Take the following hardware from the leg stand
hardware bag:
24 carriage bolts (5/16-18 x 3/4 in.)
4 leveling feet
32 flat washers (5/16 in.)
32 hex nuts (5/16-18)
Note: Remaining hardware from this bag is used for
mounting leg stand on the table saw base.
• Take 4 legs and 8 braces from loose parts.
• Place a short upper brace inside two of the legs,
with the legs wide end up. (Upper braces have two
large holes in each end.) Make sure the two posts
on the leg align with the small holes on the brace.
UPPERBRACE
WASHER
HEXNUT
\
LOWERBRACE
LEVELINGFOOT
WASHER
Fig. 7
19 rlIIIFI"IMAN'TABLESAW315.228590
Loading ...
Loading ...
Loading ...