Loading ...
Loading ...
Loading ...
STORAGEDRAWER OR WARMING DRAWER (on some
models)
Check that storage drawer or warming drawer is cool and empty
before cleaning.
Cleaning Method:
• Mild detergent
OVEN CAVITY
Do not use oven cleaners on models with self-clean.
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
Cleaning Method:
• See the "Self-Cleaning Cycle" section, if available on your
model.
Oven Light
The oven light is a standard 40-watt appliance bulb. Before 2. Turn the glass bulb cover in the back of the oven
replacing, make sure the oven and cooktop are cool and the counterclockwise to remove.
control knobs are in the off position. 3. Turn bulb counterclockwise to remove from socket.
To Replace:
1. Unplug range or disconnect power.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
Appliance Oudets (on some mede s}
The 120-volt appliance outlet located on the control console may
be used to run portable appliances placed on countertops beside
the range.
The outlet operates independently and is not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop. Damage
to the portable appliance could result if the cooktop is hot.
Appliance Outlet Circuit Breaker:
The circuit breaker for the appliance outlet on your range is located
next to the outlet. It is rated for 12 amps.
If the circuit breaker trips, it can be reset by pressing the switch. A
delay of several minutes may be required for the circuit breaker to
cool before it will reset.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.whirlpool.com
In Canada, reference the Customer Service section at www.whirlpool.ca
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown, or a
circuit breaker is tripped.
The control displays an F9 or F9
E0 error code.
The control knob is not set
correctly.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
Push in knob before turning to a setting.
On ceramic glass models, the See the control lock keypad feature in the "Feature Guide."
oven control lockout is set.
Excessive heat around Cookware is not the proper size. Use cookware about the same size as the surface cooking
cookware on cooktop area, element or surface burner. Cookware should not extend
more than 1/2"(13 mm) outside the cooking area.
Cooktop cooking results not Control knob set to incorrect heat See "Cooktop Use" section.
what expected level
Range is not level.
Element cycling due to a
temperature limiter
Delay start is set.
Control lock is on.
Control is in Demo Mode.
Cooktop element cycles on
and off on High setting.
Oven will not operate
Level the range. See the Installation Instructions.
This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
See "Cook Time" section.
Press and hold START for 3 seconds to unlock.
Press and hold START TIME for 10 seconds to exit Demo
Mode. Demo Mode is used for display models in a showroom.
See "Electronic Oven Controls" section.Electronic oven control set
incorrectly
Oven temperature too high or Oven temperature needs See "Oven Temperature Control" in the "Electronic Oven
too low adjustment. Controls" section.
Oven indicator lights flash Power to range is turned on or See "Control Display" in the "Electronic Oven Controls"
restored, section. If the indicator lights keep flashing, call for service. See
cover for contact information.
13
Loading ...
Loading ...
Loading ...