Loading ...
Loading ...
Loading ...
MA INTENA NCE
AUGER CONTROL CABLE ADJUSTMENT
,_ WARNING: Do not over-tighten, as this may lift the
lever and cause the auger drive to be engaged
without depressing the auger drive control,
1. With the auger control lever released, the hook (A, Figure 17)
should barely touch the lever (B) without raising it. There can
be a maximum of 1/32 in. (0.8 mm) clearance.
2. To adjust, loosen the nut (C) by holding the adjusting flats (D)
and turning the nut. Then, turn the adjusting flats and hold the
adjustment screw (E). The adjustment screw is a phillips screw
and the head can be held or turned by inserting a screwdriver
through the spring (F).
3. Hold the adjusting flats and tighten the nut.
4. Start the engine and check the auger. The auger must not be
engaged unless the auger control lever is depressed.
5. With the engine running, fully depress the auger drive control
lever. The auger should engage and run normally.
I
WARMNG: The auger must stop within 5 seconds. If it I
does not, see an authorized dealer.
I
6. Release the auger control lever.
7. If the auger does not operate properly, stop the engine and
recheck the auger control cable adjustment.
8. If the drive linkage is properly adjusted, the tension of the
auger drive belt may require an adjustment. See an authorized
dealer.
CHECK THE TIRES
Check tires for damage. Check the air pressure in the tires with an
accurate gauge (see Figure 18).
,_ CAUTION: Avoid injury! Explosive separation of tire and
rim parts is possible when they are serviced incorrectly.
, Do not attempt to mount a tire without the proper equipment
and experience to perform the job.
, Do not inflate the tires above the recommended pressure.
, Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an explosion.
Welding can structurally weaken or deform the wheel.
, Do not stand in front or over the tire assembly when
inflating. Use appropriate tool that allows you to stand to
one side.
NOTICE: Check side of tire for maximum tire pressure. DO NOT
exceed maximum.
\
Adjusting Auger Control Cable Figure 17
Checking Tire Air Pressure Figure 18
21
Loading ...
Loading ...
Loading ...