Loading ...
Loading ...
Loading ...
OPERATION
BEFORE OPERATING SNOWTHROWER
Check the fasteners. Make sure all fasteners are tight.
On electric start models, the unit was shipped with the
starter cord plugged into the engine. Before operating,
unplug the starter cord from the engine.
NOTE: This snowthrower was shipped WiTH OIL in the
engine. See Check the Oil (Before Starting Engine)
instructions in this section before starting engine.
WARNING: The operation of any snowthrower can result in foreign objects being thrown into the eyes, which can result in
severe eye damage. Always wear safety glasses or eye shields before beginning snowthrower operation. We recommend
standard safety glasses or Wide Vision Safety Mask over spectacles.
SNOWTHROWER SAFETY TESTS
Test 1 = Auger/Impeller
, Release auger control (right-hand).
, Auger/impeller stops in less than 5 seconds.
Test 2 =Traction Drive
, Release traction control (left-hand).
, Snowthrower forward/reverse motion stops.
Test 3 = Free=Hand Control (if equipped)
, Engage auger control and traction control.
, Release auger control immediately followed by the traction
control (a) stops auger/impeller in less than 5 seconds, and (b)
stops forward/reverse motion of snowthrower.
DANGER: The discharge chute contains a rotating
impeller to throw snow. Never clear or unclog the
_ ischarge chute with your hands. Fingers can quickly
become caught and traumatic amputation or severe
laceration will result. Always use a clean-out tool to
clear or unclog the discharge chute.
WARNING:
, Hand contact with the rotating impeller inside the
discharge chute is the most common cause of injury
associated with snowthrowers.
, This snowthrower is capable of amputating hands
and feet, and throwing objects. Read and observe all
the safety instructions in this manual. Failure to do so
will result in death or serious injury.
OPERATE THE SNOWTHROWER
_llL CAUTION: Operation with a Snow Cab. Wind may blow
exhaust gasses back towards the operator. If you notice
the smell of exhaust, change direction of operation.
NOTICE: Do not throw snow toward a building as hidden
objects could be thrown with sufficient force to cause
damage.
1. Start the engine. See Start the Engine in this section.
2. Press the chute rotation switch (A, Figure 4) to the UP/DOWN
position to rotate the discharge chute left or right. See Dis=
charge Chute and Deflector in this section.
ld_ili CAUTION: Before operating, make sure the area in
front of the snowthrower is clear of bystanders or
obstacles.
Free-HandTM Control
Control Levers
Figure 4
12 www.snapper.com
Loading ...
Loading ...
Loading ...