Loading ...
Loading ...
Loading ...
EN
Do not use:
• cast iron griddles, ollar stones, terracotta pots, and pans;
Liquids spilled on the hot hob area can cause glass damage.
stops (when it reaches the “z” position).
UNIVERSAL LP GAS TO NATURAL GAS CONVERSION PROCEDURE
Appliance models: Gas vitroceramic cooktop models:
60 cm. 4 Burners
90 cm. 5 Burners
Burner Main injector
Ultra rapid 1.75 B mm
Rapid 1.55 mm
Semi Rapid Reduced 1.05 mm
Semi Rapid 1.20 mm
Auxiliary 0.90 mm
BURNER Ø COOKWARE DIAMETER
Ultra rapid burner From 24 to 26 cm
Rapid From 20 to 22 cm
Semi-rapid From 16 to 18 cm
Auxiliary From 10 to 14 cm
Symbol 1
Symbol 2
Symbol 3
Symbol 4
Symbol 5
PRACTICAL ADVICE FOR USING THE BURNERS
please stick to the following rules:
• use pots and pans with bottoms the same width as that of the
burners or slightly larger (see table on the right);
•
• use the correct amount of water for cooking foods and keep the pot
covered;
• make sure pots on the grates do not protrude beyond the edge of
the hob;
• in the case of pans with convex bottoms (WOK), use a support grille,
which should be positioned only on the ultra rapid burner;
• avoid accidentally knocking the hob with pans, racks, or other
kitchen utensils;
• do not leave empty steak grills over the lit burner for longer than 5
minutes.
IMPORTANT: improper use ofthe grids can damage the hob: do not
position the grids upside down or slide them across the hob.
ADAPTING TO DIFFERENT TYPES OF GAS EN
type stated on the rating plate, change the injectors.
Use pressure regulators suitable for the gas pressure indicated in the
Instruction:
•
technician;
• injector not supplied with the appliance must be ordered from After
Sales Service;
• adjust the minimum setting of the taps.
NOTE: when liquid petroleum gas is used (ULPG), the minimum gas
setting screw must be tightened as far as it will go.
knobs, please contact the After Sales Service to replace the burner
tap if found to be faulty.
IMPORTANT: when the gas cylinder is adopted, the gas cylinder or
gas container must be properly settled (vertical orientation).
asbestos mat, between pan and pan
support as serious damage to the appliance
my result.
Do not remove the pan support and
enclose the burner with a wok stand as this
cooktop.
Do not use large pots or heavy weights
Locate pan centrally over the burner so that
it is stable and does not overhang the
appliance.
Use only a wok support supplied or
recommended by the manufacturer of the
appliance.
1. Remove each burner cap and burner skirt.
2. Remove
the Universal LP Gas main injector with a 7 mm/VF tube
spanner and replace with the appropriate size Natural Gas injector for
each burner. The following injector sizes are required for Natural Gas:
4. Disconnect gas inlet pipe from the Universal LP Gas test point inlet
appliance.
6. Fit the Natural Gas Regulator supplied in the conversion kit.
7. Connect the gas supply to the Regulator.
9. Adjust the gas pressure to 1.00 kPa.
10. Remove the control knob, with a thin shaft blade screwdriver down
the centre of each gas valve shaft, screw the by-pass injector
stable.
11. If not already removed, remove the "Only for use with Universal LP
Gas" label adhered to the bottom panel near the gas connection.
12. Fit the new data label included in the gas conversion kit.
Loading ...
Loading ...
Loading ...