Loading ...
Loading ...
Loading ...
EN
When the appliance is connected to the electricity main by a socket:
• Fit a standard plug suited to the load indicated on the data label to the cable.
•
Letter L (live) = brown wire;
Letter N (neutral) = blue wire;
Earth symbol = green - yellow wire.
• The power supply cable must be positioned so that no part of it is able to reach a temperature of 90 °C.
• Never use reductions, adapters of shunts for connect ion since these could create false contacts and lead to dangerous overheating.
When the appliance is connected straight to the electricity main:
• Install an omnipolar circuit-breaker between the appliance and the electricity main. This circuitbreaker should be sized according to the load
rating of the appliance and possess a minimum 3 mm gap between its contacts.
• Remember that the earth wire must not be interrupted by the circuit-breaker.
•
Fig. 5
Fig. 5/A
HOTPLATES WITH 4 BURNERS
IGNITION
GENERATOR
N
L
HOTPLATES WITH 5 BURNERS
IGNITION
GENERATOR
ELECTRIC
WIRING
DIAGRAM
ELECTRIC
WIRING
DIAGRAM
N
L
ELECTRICAL CONNECTION
IMPORTANT: the appliance must be installed following the manufacturer's instructions. The manufacturer will not be liable for injury to
persons or animals or property damage caused by an incorrect installation.
of the appliance 380 mm from the right hand side. The voltage and power consumption are detailed on the underside of the appliance.
Ensure that the appliance is correctly rated to the supply. Connect appliance by way of a switched power point.
THE APPLIANCE MUST BE EARTHED
Warning: in order to avoid any hazard, any electrical work performed on this equipment or its
persons. The socket outlet for this cooktop shall be installed near the cooktop and shall be easily
accessible.
The electrical connections ofthe appliance must be carried out in compliance with the provisions
and standards in force.
Before connecting the appliance, check that:
• The voltage matches the value shown on the rating plate and the section of the wires of the
electr
ical system can support the load, which is also indicated on the rating plate.
• The electrical capacity of the mains supply and current sockets suit the maximum power rating of
the appliance (consult the data label applied to the underside of the cooktop).
•
standards in force. The manufacturer declines all responsibility for failing to comply with these
provisions.
the wires of the socket is suitable for the power absorbed by the appliance.
Before performing any service on the electrical part of the appliance, it must absolutely be disconnected from the electrical network.
CAUTION!
The manufacturer cannot be responsible for the missing earthing of the appliance. Electrical connection must be carried out in compliance
with local regulations. This appliance must be connected directly to the mains supply.
Ensure the appliance is installed by an authorised person in accordance with AS/NZS 3000 wiring rules.
"The devices intended to ensure the omnipolar disconnection of the cooktop from the supply network must comply with the requirements
of the AS/NZS 3000".
Always disconnect the appliance from the electricity main before making any adjustments.
All seals must be replaced by the technician at the end of any adjustments or regulations.
Our burners do not require primary air adjustment.
a) Data Label
The Data Label is located on the underside of the cooktop. A duplicate Data Label is supplied to adhere in an accessible area next to the cooktop.
This cooktop is suitable for Natural Gas and Universal LP Gas; ensure that the available gas supply matches the Data Label.
b) Before Leaving
instruct the user on the correct method of operation. In case the appliance fails to operate correctly after all checks have been carried out, refer to the
authorised service provider in your area.
Loading ...
Loading ...
Loading ...