Loading ...
Loading ...
Loading ...
GAS CONNECTION
Fig. 3
Fig. 4
Before installation, check that the gas type (natural gas or Universal LPG) of the cooker is suitable for the gas type available for the installation. Check that
the gas supply pressure is consistent with the values indicated in the "Injectors table." This will ensure the safe operation and longevity of your appliance
(in compliance with ISO 7 thread).
F
or NG models, the gas supply is connected to a regulator, which is supplied. The inlet connection has ½” B.S.P female thread. THE ELBOW ON THE
APPLIANCE MUST BE HELD FIRMLY WITH A SPANNER. DO NOT OVER TIGHTEN. The regulated pressure for NG is 1.00kPa.
event of an emergency or service.
T
he gas connection is located in the rear and on the right hand underside of these appliances:
24 mm (mod: GGA24BKAUS),
230 mm (mod: GGA34BKAUS).
B. If installing with a hose assembly, install with a hose assembly that complies with AS/NZS 1869, 10mm ID, class B or D, no more than 1.2m long and in
accordance with AS/NZS 5601. Ensure that the hose does not contact the hot surfaces of the hot plate, oven, dishwasher or any other appliance that may
be installed underneath or next to the hot plate. The hose should not be subjected to abrasion, kinking or permanent deformation and should be able
connections tested for gas leaks.
Natural Gas
Natural Gas installations require the connection of a gas regulator at the appliance. This regulator is supplied with the appliance on purchase. Assemble
supply side of the regulator must be provided by the installer.
In a ULP Gas installation the gas pressure regulation is provided at the supply cylinder located outdoors, and an additional regulator at the appliance is
After installing the gas supply and making all connections check thoroughly for possible leaks. Turn all control knobs on the unit to the "OFF"
position. Open the valve on the gas supply. Using a soap and water solution, check each gas connection one at a time by brushing the solution over
the following:
•
Burner cap on correctly
•
Burner positioned correctly
•
Burner vertically aligned with injector nipple
In some cases, the burners will fail to ignite immediately and seem to blow lightly when they do ignite; this is usually due to air in the gas pipe, which
should clear itself within seconds of operation. If satisfactory performance cannot be obtained after following the instructions given, contact your
After Sales Service for advice and assistance.
Loading ...
Loading ...
Loading ...