Loading ...
Loading ...
Loading ...
Setting Surface
Controls
FEATURE OVERVIEW
Sizes of Surface Burners
Assembly of Surface
Burners
Sizes of the Surface Gas
Burners
Your gas range issupplied with
the following 4 different surface
gas burners:
• Simmer Burner (5,000 BTU)
• Standard Burner (9,500 BTU)
• Power Burner (12,000 BTU)
• Power Burner (14,200 BTU)
When setting up the gas range
for the first time, make sure that
the correct Burner Heads, Burner
Caps and Burner Grates are
located as shown in Figure 1.
Burner Cap
(Standard)
Left Front
Orifice Holder
% !
.LargeBurnerCap
"POWER"
BurnerHead
ft Sma
OrificeHolder BurnerCap
Extra Large _---"81MMER"
BurnerCap-,,_ o _ BurnerHead
(5,000BTU)
"POWER"
BurnerHead Right Rear
(14,200BTU) Orifice Holder
RightFront
Orifice Holder
Figure 1
Grate
Burner
Grate
Cap
Burner
Head
Orifice
Holder
Electrodemustbe
locatedproperlyin slot
of each BurnerHead
Figure 2
Assembly of the Surface Burner Heads, Burner Caps and
Burner Grates
It isvery important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly
and at the correct locations.
1. Place all 4 Burner Heads in the correct locations (See Fig. 1).
Make sure that the correct Burner Head is placed with the
corresponding Orifice Holder and that the Electrode is located
properly in the slot of each Burner Head (See Fig. 2). Proper
Burner Head placement insures that each Burner will have the
correct spark required for surface gas ignition.
2. Place the correct Burner Caps at each of the burner locations (Burner
Cap Pilot Hole must face up). Each of the 4 (four) Burner Heads
MUST have a Burner Cap installed to insure proper ignition and gas
flame size and must be in place with the Pilot Hole facing up
BEFORE placing the Burner Grates (See Fig. 2).
3. Place the 2 (two) cast iron Burner Grates supplied with the range.
Carefully line-up the 2 Grate Pins on each Grate with the Cap Pilot
Holes in the 2 Burner Caps on each side of the range. DO NOT force
the Burner Grates onto the Burner Caps. Forcing the grates down
onto improperly installed Burner Heads and Burner Caps may damage
the gas burners. Each Burner Cap is designed with a Cap Pilot Hole
in the top center of the Cap. Visually check that ALL the Grate Pins
line up into the Burner Cap Pilot Holes (See Figure 2). Properly
installed Burner Grates wilt rest with all four Grate legs on the
glass .
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use. If burner orifice becomes
blocked with food spillage, service would be required.
7
Loading ...
Loading ...
Loading ...