Loading ...
Loading ...
Loading ...
Setting the Clock
FEATURE OVERVIEW
Setting the Clock
Changing between 12 or
24 hour display
Setting the Clock
The CLOCK (_ pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation• When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with "PF" (power
failure, See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press 0" "CLO" will appear in the display (Fig. 2).
2,
Press padstosetthetimeofdayto1:30
(Fig. 3). "CLO" wilt appear in the display• Press @.
"CLO" will disappear and the clock will start (Fig. 4).
PRESS
O
Figure 1
DISPLAY
Changing between 12 or 24 hour time of day display:
1. Press and hold @ for 6 seconds (Fig. 3). While holding the
pad down the current time of day will remain and "CLO" will
disappear from the display (Fig. 4). CONTINUE holding the pad
until a beep is heard•
for 6 seconds
2. The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).
3. Press (_) to switch between the 12 and 24 hour time of day
display. The display willshow either "12:00" (Fig. 5) or "24:00"
(Fig. 6).
4. Press @ to accept the change or press _ to reject the
change.
5. Reset the correct time as described in To set the Clock above•
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
15
Loading ...
Loading ...
Loading ...