Loading ...
Loading ...
Loading ...
24
Stability of the "low" setting on the burners may vary
due to wind direction, unit confi guration, and position. If
your burner goes out when set on low, adjust the valve
"low" setting.
To adjust the valve "low" setting:
1. Ensure the unit is completely cool and the knobs
are in the OFF position.
2. Remove the control knobs and control panel. See
the CONTROL PANEL REMOVAL section for panel
removal instructions.
3. Re-install the control knobs on the valve stems with
the control panel removed.
4. Light the burner on HIGH, then immediately turn the
burner to LOW setting. While the burner is lit, remove
the control knob from the valve.
5. Locate the FLATHEAD adjustment screw found above
the valve stem and below the manifold (see Fig.
24-1).
6. Using a flathead screwdriver, slowly turn the
adjustment screw a little at a time (30° to 45°) in either
direction. Adjust the screw as needed until the fl ame is
approximately
1
/4" in height from all the burner ports,
and the fl ames are stable.
CAUTION: Only adjust the FLATHEAD screw.
Adjusting other screws may result in
a dangerous gas leak.
7. Once the appropriate setting is reached, re-install the
control knob and shut off the burner valve.
8. Repeat this procedure for the other burner valve, if
needed.
9. Re-install the control panel.
Fig. 24-1 Valve adjustment screw location
Valve
adjustment
screw
Valve stem
(Manifold)
(Manifold)
VALVE "LOW" SETTING ADJUSTMENT
Loading ...
Loading ...