Loading ...
Loading ...
Loading ...
14
L-C2-463
REV 0 - 1412011255
AOG units are equipped with orifi ces for natural gas, unless
otherwise indicated. For use with propane gas, smaller
orifi ces must be installed to avoid hazardous overheating.
Please refer to Table 1 for the correct orifi ce size. Check
the orifi ce size by following the instructions below. The drill
size is stamped on the orifi ce. If the number is not visible
you may have to remove the orifi ce (as detailed below) to
read the number stamped on the side of the orifi ce.
IF YOU ARE NOT SURE YOU HAVE THE CORRECT
SIDEBURNER ORIFICE SIZE (OR WISH TO CHANGE
THE ORIFICE), FOLLOW THE STEPS BELOW.
CAUTION: If the burner has been in use, wait until
the burner and its components are cool
to the touch.
IMPORTANT: When converting orifi ces for different gas
type, the regulator must also be converted
for the new gas type. Reference the
CHECKING AND CONVERTING THE
REGULATOR section.
1. Remove sideburner cover and lift off cooking grid.
2. Remove the control panel. See the CONTROL
PANEL REMOVAL section for step by step
instructions.
3. Reach up under the burner support and remove
the burner retaining clip (see Fig. 14-1), located
at the rear of the burner pipe.
CONVERTING THE GAS TYPE
Fig. 14-1 Remove burner clip
Procedure continued on next page
Loading ...
Loading ...
Loading ...