Loading ...
Loading ...
Loading ...
12
INSTALLATION
COUNTER PREPARATION
Consult Table 1 for enclosure cut-out dimensions. If the counter or any supporting construction is combustible,
the COMBUSTIBLE ENCLOSURE CUT-OUT section must be followed before beginning the installation.
This double sideburner must be supported by the stainless-steel hanger extending from the upper portion of the
frame. The hanger rests on the left, right, and back of the countertop.
The control panel is designed to sit fl ush against the enclosure front wall (see Fig. 12-2). If the enclosure countertop
extends beyond the front wall, creating a countertop overhang (see Fig. 12-1), it must be cut fl ush with the front
wall for the width of the control panel or a gap will be created exposing the forward portions of the left and right
side fi re walls of the unit. Reference the MODEL SPECIFICATIONS section.
Note: It is not necessary to remove the control panel or control knobs to install this unit.
GAP CREATED
IDEAL
Flush-mounted
control panel
Proposed cut-
out in overhang
(Countertop) (Countertop)
Overhang
Control panel
stops here
Fig. 12-1 Fig. 12-2
L-C2-463
REV 0 - 1412011255
Procedure continued on next page
Fig. 12-3 Gas connection diagram
Fig. 12-4
Flex connector
(Side burner)
Adapter
Regulator
Gas supply
6" Sideburner clearance
Dedicated
manual
shut-off valve
Procedure continued on next page
CONNECT THE GAS SUPPLY
Always ensure the orifi ces and regulator (if applicable)
are set for the gas type your unit is to be installed to.
For propane cylinders:
For connecting a propane unit to a portable propane tank,
read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE
GAS CYLINDERS.
Note: When a propane cylinder is installed inside
of the enclosure, the guidelines found in the
ENCLOSURE REQUIREMENTS section
MUST be followed.
For household propane or natural gas units:
THE ATTACHED FLEX LINE AND REGULATOR MUST
BE PROPERLY ATTACHED TO A RIGID GAS SUPPLY
PIPE . See Fig. 12-3.
CAUTION: Use only C.S.A. listed stainless-steel fl ex
connectors within the enclosure.
WARNING
A rubber or plastic connector will rupture or leak,
resulting in an explosion or serious injury if used
inside the appliance enclosure.
1. Route the attached fl ex connector with regulator
(located underneath the sideburner) to the gas-
supply stub. (An adapter is required if the gas-supply
stub is other than
1
/
2
" in diameter.)
2. Turn OFF the gas supply at the source. Then
connect the fl ex connector with regulator to the
gas-supply stub. Use pipe joint compound that
is resistant to all gasses on the male pipe fi tting
and tighten securely. DO NOT use pipe joint
compound to connect fl are fi ttings.
Note: The regulator may need to be disconnected
from the fl ex connector to make the proper
connections. Reconnect the fl ex to the
regulator if removed.
Loading ...
Loading ...
Loading ...