Loading ...
Loading ...
Loading ...
22
Changing The Water and Air Filters
Your refrigerator is equipped with separate water and air
fi ltering systems. The water fi lter system fi lters all the water
used to produce ice. The air fi lter removes odors and
impurities from the refrigerator compartment.
Push Water Filter Button
NOTE
The control panel includes controls to monitor the status of
your water and air fi lters. See the Controls section for more
information.
About your advanced water fi lter
The NGFC-2000 fi lter system is tested and
certifi ed by NSF International to NSF/ANSI
Standards 42, 53 and 401 for the reduction
of claims specifi ed on the performance data
sheet.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system. Systems certifi ed for cyst reduction may
be used on disinfected waters that may contain fi lterable
cysts.
• Rated Capacity - 240 gallons
• Rated service fl ow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per square
inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
Water fi lter
The water fi lter is located at the lower left side of the fresh
food compartment.
Replacing your TruWater water fi lter
In general, you should change the water fi lter every six
months to ensure the highest possible water quality. The
Water Filter Status light on the Touch Panel prompts
you to replace the fi lter after the six month time period has
elapsed. The water fi lter status light on this model is not
performance tested or certifi ed by NSF.
If your refrigerator has not been used for a period of time
(during moving for example), change the fi lter before
reinstalling the refrigerator.
It is not necessary to turn the water supply off to change
the fi lter. Be ready to wipe up any small amounts of water
released during the fi lter replacement.
1 Push the fi lter release button above the cartridge to
disconnect it.
2 Slide the old water fi lter cartridge straight out of the
housing and discard it.
3 Unpack the new fi lter cartridge and remove the two
protective caps covering the inlet and exit of the
fi lter. Slide the fi lter gently into the housing until it
stops against the snap-in connector at the back of the
housing.
Loading ...
Loading ...
Loading ...