Loading ...
Loading ...
Loading ...
Fig. C G H
E
C .....................ZZZZ_
N
J K
U
R
S
UNPACKING AND CHECKING
CONTENTS (Fig. C)
This Bench Grinder wHUrequire a minimaU amount of
assembly, A 12mm x lOmm open end wrench is
provided for mounting the Tool Rest Assemblies and
the Spark Arrestor Assemblies,
1, Remove parts from all of the cartons and lay them
on a dean work surface,
2, Remove any protective materials and coatings from
all of the parts and the bench grinder, The protec-
tive coatings can be removed by spraying WD-40
on them and wiping it off with a soft cloth, This may
need to be redone several times before all of the
protective coatings are removed completely,
CAUTION: DO NOT use acetone, gasoline or
lacquer thinner to remove any protective coatings
on your table saw,
3, Compare the items to Figure C; verify that all items
are accounted for before discarding the shipping
box, if there are any missing parts, call Customer
Helpline 1°800-897°7709,
if any parts are missing, do not attempt to plug in the
power cord and turn "ON" the Bench Grinder, The
Bench Grinder can only be turned "ON" after all the
parts have been obtained and installed correctly,
The following items are to be provided in the shipping
box:
A, Grinder (not shown)
B, Eyeshield (2)
C, Carriage head screw M6 x 80mm (2)
D, Spacer (2)
E, Fiat washer M6 (2)
R Eyeshield knob (2)
G, Wheel dresser
H, Hex head screw 5/16-18 x 1/2" (4)
I, Fiat washer 5/16" (4)
J, Spark arrestor, left
K, Spark arrestor, right
L, Fiat washer 1/4" (2)
M, Hex head screw 1/4-20 x 1/4" (2)
N, Tool rest support, left
O, Tool rest support, right
R Tool rest, right
Q, Drill bit sharpening plate
R, Tool rest knob (2)
S, Fiat washer 5/16" (2)
1, Tool rest, left
U, Special wrench
V, Quench tray (not shown)
Loading ...
Loading ...
Loading ...