Loading ...
Loading ...
Loading ...
SPARK ARRESTORS (Fig. G)
Assembb the Spark Arrestors (A) to the inside
surface of the Wheel Covers (B) with the flat
washers (C) and hex head screws (D) as shown,
See Figure G,
2, Adjust each Spark Arrestor until the lower edge (E)
is 1/16" from the grinding wheel, Firmly tighten the
hex head screws, Bee Figure G,
Fig. G
B
WORK UGHT (Fig. J)
The Bench Grinder is provided with a Fbxibb Work
Light to assist in visiblity of the workpbce,
The Bench Grinder is NOT provided with a Nght bulb for
the Fbxibb Work Light,
To reduce the risk of fire, use a 120 volt, 40 VVattor less
Track Light Bulb, Type R20, medium base or equivalent
(not included), DO NOT use a light bulb that extends
past the end of the light housing,
The Flexible Work Light may be turned "ON" or "OFF"
by using the rotary switch (B) on the top surface of the
housing (A), The switch can be rotated in the clockwise
direction only, See Figure J,
NOTE: The Flexible Work Light can be turned "ON" or
"OFF" even if the Bench Grinder is turned "OFF",
CAUTION: The Flexible Work Light housing wiii remain
hot for a few minutes after turning it "OFF", Avoid con-
tact with housing until it is cool,
EYESHIELDS (Fig. H)
Assemble the eyeshield (C) to the Spark Arrestor
(A) inserting carriage head screw (B) through
Eyeshield, the Spark Arrestor, and the Spacer (D)
as shown, Bee Figure H,
2,
Assemble the fiat washer (E) and Lock Knob (F)
to the carriage head screw and tighten until the
Eyeshield remains in the desired position,
See Figure H,
E
Fig. J
A
B
10
Loading ...
Loading ...
Loading ...