Loading ...
Loading ...
Loading ...
B102188-0-0114Page 18
GRILL ASSEMBLY
Assemble Drain Pan
Note: Drain pipe and valve coponents are packed inside the
smoker box.
1. Lightly spread pipe sealant on all threads before assembling
to the drain pan.
2. Thread the 3/4” pipe into the bottom of the drain pan and tighten.
3. Assemble the two 45° elbows as shown in Figure 23.
Note: Make sure of the mountings (posts, carts, etc.) being
used before tightening to ensure that the ttings are set to the
proper position.
DRAIN PAN
3/4” PIPE
45° ELBOWS
FOR USE ON ALL POSTS
AND DCB AND PCB CARTS
FOR USE ON PSCB CART
DRAIN PAN
3/4” PIPE
45° ELBOWS
PIPE SEALANT OR
TEFLONTAPE
PIPE SEALANT OR
TEFLONTAPE
Figure 23
Install the Drain Pan Assembly
1. Lower the drain pan into the lower casting with the drain pipe on
the right side. Pass the pipe through the oval hole in the bottom
of the casting, making sure the pipe extends out through the
bottom of the casting and the pan is sitting level on the holding
tabs. See Figure 24.
DRAIN BUCKET HANGER
DRAIN SHUT OFF VALV
E
Figure 24
2. Slide the drain bucket hanger into place over the pipe and
screw on the drain shut off valve and tighten.
Note: Position Drain Shut Off Valve so it does not interfere with
the wall of the grill head.
3. Set cooking grids in place.
Note: The grids are designed for two levels of cooking.
4. Hang the drip bucket on the drain bucket hanger.
NOTE: If the grill was installed on a cart, make sure to install the
cart’s heat shield before use.
Loading ...
Loading ...
Loading ...