Loading ...
Loading ...
Loading ...
20
INSTALLATION INSTRUCTIONS
8. What to do if your product is unstable
A Gently push the refrigerator back until the rear
rollers contact the floor.
z
Measure the gap under the front foot, which has
come off the floor.
z
Obtain some solid packing material (hardwood,
plastic,etc.) which fits firmly into the gap
under the foot.
Note: do not use metallic materials that may corrode,
stain and/or damage floor coverings.
B Wind both front feet up and roll the product
out ofposition.
z
Place the packing material in the location diagonally
opposite the front roller that lifts off the floor.
z
Make sure the packing material stays in place when
the product is pushed back into position.
z
Ideally, the packing material is large enough to
rest against the back wall so as to prevent it from
moving when the cabinet is pushed into position.
Wall behind refrigerator
For example: if this foot lifts off the floor when
pushing gently on the top front of the refrigerator
Packing material goes under rear roller
diagonally opposite front foot that lifts
Stabilising your refrigerator
C Roll the refrigerator back into position and adjust front feet as per step 6
C
.
(Check alignment and door closing action are satisfactory).
z
Make small adjustments to front feet where necessary.
z
Check that the product is stable (all 4 feet are on the floor).
If not, repeat 8
A
and 8
B
.
This foot lifts off the floor
when top front is gently
pushed back
Example only
Unlevel floor
Unstable refrigerator
Loading ...
Loading ...
Loading ...