Loading ...
Loading ...
Loading ...
INSTALLING CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed, Use only the
instructions that apply to the type of shaft and shield
that your unit is equipped with,.
FOR CURVED SHAFT TRIMMERS
Place the cutting attachment shield and spacer against
tube as shown in (Fig. 1),Use the 2 screws provided
to clamp the cap and shield onto the tube. Tighten the
screws evenly. Make sure the shield does not touch
any rotating parts,
CuttingAttachment Shield
Cap
INSTALLING THE D-HANDLE AND LOWER HANDLE
STRAIGHT SHAFT AND ACCESSORY READY
TRIMMERS
1,,Locate the 4 screws includedin the tool kit,
2.Assemble the upper and lower handle parts and 4
screws as shown in (Fig. 3),positioning the handle
parts evenly over the rubber sleeve on shaft. Do not
completely tighten.
3.While holding the unit in the operating position (Fig..
14),position the D-handle to the location that pro-
vides you the best grip.
&Tighten the clamp screws evenly, until the D-Handle
issecure_
Attaching
Screws "_'I f _
(__!. D-Handle
"" Washer
Attaching Screws
Fig.
FOR STRAIGHT SHAFT TRIMMERS
Place the cutting attachment shield onto the shaft
mount.. Install using provided hardware in the sequence
as shown (Fig,2)_
Sha_ Mount
LowerHandle
Fig..3
CURVEDSHAFTTRIMMERS
1,Installing the D-Handle (non detachable model).,
2,.Installing D-Handle over the tube in desired position,
3, Install the fasteners asshown (Fig,,4)_
&Tighten until D-Handle issecure.
Plate Washer
W ,he,
jx
Lock Washer Attach
uttingAttachment Shield
! Screws
Fig 2
I WARNING: 1
To proven1 sedous injury, never operale the
trimmer wllhoul the culting attachment in
place,
LEHR I ALL RIGHTS RESERVED2008-2009
Loading ...
Loading ...
Loading ...